BIQU BX linear rail first test.

Linear rail was added there because I seriously hate those silly wheels it was running on. It was just not accurate or reliable enough. Fitting a linear rails from a Ender 3 basically.. Seriously not fun.

Also a Z-sync belt was added because when the printer was powerdown, the right-hand side dropped down a fraction more than the left which would throw out all the bed levelling all the time.

I also had endless problems with the end stops as well (basically does not have any!!)

https://www.exxoshost.co.uk/forum/viewtopic.php?f=18&t=1789&start=1770#p77701

and

https://www.exxoshost.co.uk/forum/viewtopic.php?f=35&t=4741

Видео BIQU BX linear rail first test. канала exxosuk