Starting an Evinrude 150 outboard for the first time in years
In this video go through the things to check and do before starting an outboard up for the first time. This Evinrude 150 turns out to have a few problems that need fixing before it can be started and run. It has oil in the carburettors, a stuck gear selector. Because the gear selector was stuck and the controls had been forced I assumed that had caused the bend in the rod but apparently that is factor bent. More information in this video https://youtu.be/Ufy6W9EI1cg
All music available at http://soundscloud.com/dangarstu
All writing available at http://www.lulu.com/spotlight/dangarstu
Видео Starting an Evinrude 150 outboard for the first time in years канала Dangar Marine
All music available at http://soundscloud.com/dangarstu
All writing available at http://www.lulu.com/spotlight/dangarstu
Видео Starting an Evinrude 150 outboard for the first time in years канала Dangar Marine
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Yamaha F225 Outboard Rebuild | Yamaha F225 Powerhead Rebuild | Boats.netHow to service an outboard motorInstalling HyDrive hydraulic steering in a boatStarting the Evinrude 150 for the first timeHow to Replace the Water Pump on a Johnson Evinrude 85-300hp OutboardStarting An Outboard Motor That's Been Sitting!Free Boat and Motor. Sitting 20 Years, Will it Still Run?Two stroke outboard run without oil in fuelEvinrude VRO pump and carburettor cleanSaving a sunk Honda BF40 outboard motorWill This Abandoned Outboard Run Again?Evinrude 150 autopsyHow To: Replacing the Optical Sensor on a Johnson / Evinrude Outboard MotorPimping Out My New Boat!We Restored A Cheap Boat!Outboard carburettor tuningHOW TO SAVE A OUTBOARD THAT’S BEEN SITTING FOR YEARSJohnson / Evinrude primer solenoidBuying more cheap WaverunnersJohnson / Evinrude fuel pump service