DCC Coil Decoder for Rokuhan, Märklin track 1 drives and motor drives

NMRA-DCC Coil-Decoder (16LF18313_Rokuhan)
The coil decoder can be used for Rokuhan switches, Märklin track 1 switch drives and motor drives.
Voltage proof up to 30v and 2A output current. The coil decoder can be programmed using the button for the address and CVs in direct mode or POM (programming on main).

Program
Press the button and send out the switching signal. The decoder should then react to the signals from the switches on the left and right (Intellibox Keyboard mode red and green buttons).

The decoder is always programmed for both signals. Depending on which signal was detected during programming, the outputs are swapped and CV39 bit 2 is set. The relay output is used to polarise the frog of the turnout with an extra relais connected or to report the position. This output can be also used for a separate address to switch (CV39.7=1, Address-1).

CV1 (CV513): Decoder address low-order bits, 6 or 8 bits LSB
CV7 (CV519): Manufacturer version number
CV8 (CV520): Manufacturer identification
CV9 (CV521): Decoder address high-order bits, 3 bits MSB
CV29.7 = 1, accessory decoder
CV33 (CV545) Time clockwise rotation (green) 1=100ms, 100=10s
CV34 (CV546) Time counterclockwise rotation (Red) 1=100ms, 100=10s
CV35 (CV547) greenPWM
CV36 (CV548) redPWM
CV37 (CV549) Acknowledge Power
CV38 (CV550) RailCom cutout 31 x 16µs = 496µs
CV39 (CV551): Additional configuration
CV39.7 = Activate second address (base address -1)
CV39.6 = Activate POM mode
CV39.5 = Deactivate button
CV39.4 =
CV39.3 = Switch off relay output
CV39.2 = Reverse relay output
CV39.1 =
CV39.0 = Switch output ports

If the POM mode is deactivated it can be activated with CV40 & CV41Write first CV40 = 255 and then CV41 = 170 via POM mode will set CV39 bit 6 (PomOn).

A consumer must be connected for read out.

Видео DCC Coil Decoder for Rokuhan, Märklin track 1 drives and motor drives канала Georg Ziegler