Replacing the Timing belt and head gasket on an MGF
John Paul at RimmerBros takes us through the process of changing the timing belt and head gasket on an MGF.
*EDIT* At 21:45 John Paul states that you tighten to 180 Nm twice. This is corrected to 180 degrees twice, shortly after, but in order to avoid confusion, DO NOT tighten your head bolts to 180Nm. The procedure is 20Nm then 180 degrees twice.
Видео Replacing the Timing belt and head gasket on an MGF канала Rimmer Bros TV
*EDIT* At 21:45 John Paul states that you tighten to 180 Nm twice. This is corrected to 180 degrees twice, shortly after, but in order to avoid confusion, DO NOT tighten your head bolts to 180Nm. The procedure is 20Nm then 180 degrees twice.
Видео Replacing the Timing belt and head gasket on an MGF канала Rimmer Bros TV
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Replacing the head gasket, water pump and cambelt on a Rover 75 1.8 turbo.
MG TF Restoration ¦ Cam Gear Removal & Seal Replacement
Old Top Gear 2001 - Sportscar Shootout
ROVER K Series Cambelt Change Video
Pumping the hydragas suspension up on an MGF
HOW TO CHECK FOR A BLOWN HEAD GASKET
How to Tell if Your Timing Belt's Been Replaced
MG TF Water pump replacement
Rover - Variable Valve Control - VVC (1995)
How to Clean Convertible Top & Restore "Yellow" Window"
MGTF 160 VVC Solenoid problem fixed
MG TF Aligning timing marks
Fifth Gear: Series 1 - Episode 6
MGF REAR SUSPENSION SPHERE CHANGE/REPLACE -DIY-RE-GAS
K series - How to Make it Reliable. 4 steps. N Series Gasket, Oil Rail, PRT, Bolts
MGTF160 Heater Blower Resistor Pack Replacement
Used MG-F Convertible Overview - Are They A Reliable Car?
Fuel Line Replacement ¦ MG TF Restoration
MG Rover K Series Head Gaskets Review - The 3 Types Why 2 Fail
MGF20 - 20 Years of the MGF