STABILIZER BAR INSTALLATION
1.5 years ago, I removed stabilizer bar. Without a stabilizer, suspension works more softer, but car lurches in turns and swings in the wind. Now I have decided to install it back. First, I disconnected steering connectors of the EPC ECU, then steering column bolt. Disconnected the steering tie rods. I didn't detach lower arms, they rested on the wheels. I disconnected the exhaust pipe, its rubber bands, and oxygen sensor connectors. Disconnected engine anti rol rod. Holding subframe on Jack, I unscrewed bolts, slowly lowered the subframe a little and installing stabilizer
Видео STABILIZER BAR INSTALLATION канала Boomer Garage
Видео STABILIZER BAR INSTALLATION канала Boomer Garage
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Cheapest springs for Mitsubishi Colt - StelloxGames comparsion | Bus stopsPREPARING CAR FOR WINTERCar fasteners clips from China for 1$DOOMER gameWheel alignment at home with thread, ruler and grainMITSUBISHI COLT Polyurethane bushing of front armMitsubishi Colt front bumper air dam skirtСlicking noise in car . I try to fixMist Survival HOW TO GET DOGI'm driving a car to get waterMITSUBISHI COLT REPAIRED CAR FUEL TANK HATCHI was driving my Mitsubishi Colt and met ducks #shorts #duckCyberpunk 2077 SASQUATCH boss in I walk the line missionDIESEL BROTHERS TRUCK BUILDING SIMULATOR rear frameA lot of snow Arrived in my garageMy Garage HOW TO REMOVE RUSTSleep in car again | Made a bedHow windshield wipers workMITSUBISHI COLT Rod/strut stabilizer to from Mitsubishi Lancer