How to Remove Machine Rust FAST- The Secret to Silky Smooth Surfaces
This video shows how to remove rust that may develop on your cast iron machine surfaces. Then we look at what product to use on the surface to buff it out and make it super slick.
Mirka 4 1/2-Inch by 9-Inch Very Fine Scuff Pads (Red) 360 grit - https://geni.us/5K5gA on Amazon (commissions earned)
GlideCote Aerosol Top-Cote - https://geni.us/YJ6T on Amazon (commissions earned)
My Favorite Tools - Insider Carpentry Amazon Site - https://www.amazon.com/shop/insider_carpentry
Support more content like this by becoming a PATREON SUPPORTER - https://www.patreon.com/insider_carpentry
INSTAGRAM - www.instagram.com/insider_carpentry
Видео How to Remove Machine Rust FAST- The Secret to Silky Smooth Surfaces канала Insider Carpentry - Spencer Lewis
Mirka 4 1/2-Inch by 9-Inch Very Fine Scuff Pads (Red) 360 grit - https://geni.us/5K5gA on Amazon (commissions earned)
GlideCote Aerosol Top-Cote - https://geni.us/YJ6T on Amazon (commissions earned)
My Favorite Tools - Insider Carpentry Amazon Site - https://www.amazon.com/shop/insider_carpentry
Support more content like this by becoming a PATREON SUPPORTER - https://www.patreon.com/insider_carpentry
INSTAGRAM - www.instagram.com/insider_carpentry
Видео How to Remove Machine Rust FAST- The Secret to Silky Smooth Surfaces канала Insider Carpentry - Spencer Lewis
Показать
Комментарии отсутствуют
Информация о видео
24 апреля 2021 г. 1:00:05
00:05:18
Другие видео канала
Arch Beams part 5 - Flush TrimmingUsing a Tilt Mortiser for Iron Balusters on Stair Handrail - Clean Installation with Square MortisesBIG CHALLENGES On This NEW PROJECT: THE MODERN RETREATThe Debrief | Episode 1: Finished Product Showing How It All Came Together | The CliffsWhy So Expensive??? Insider Guide to Deep Mortising Pocket Door HardwareNew Shop Update | Finally Moving In!!!COFFERED CEILING - Part 1 - Working Alone Is Easier Than You ThinkMonster Home Build - The Struggles On Our Current Project...WAS IT WORTH THE STRUGGLE???... My BIGGEST SOLO Trim Job...A Secret Door You've Never Seen...BURNED OUT... But I'm Back...Finally! A Trim Guys Shop Tour: The Truth About Small Shops...THIS DETAIL WAS A FIRST... (Lost my shirt on this one...)Lifting the Ring of Despair...this could get expensive... Part 3/3This was TRICKY... How to Make a Secret Door In Wainscoting: Part 2/2Chasing the Perfect Van Setup | The Build OutRidge Beam Masterclass | THIS SCRIBE WAS INSANE!!! 😬😬The Strongest Crown Molding Outside Corner Joints - The Dowel TrickHow to Assemble a Shop Built Staircase - A Learning Experience...Tape Miter Folding 12' Beams - Perfect Beam Assembly with Just Tape