HF Transmitter #09 - Directional Coupler, LPF & Antenna Relay
Immediately downstream of the final power amp, I'm adding a LPF (low pass filter), a directional coupler, and an antenna relay - all on a common printed circuit board.
The directional coupler will allow me to measure forward and reflected RF power, so that I can calculate in the Arduino software the transmitted power and the standing wave ratio (SWR).
No endorsement is made nor implied to any commercial products referenced in this episode.
Видео HF Transmitter #09 - Directional Coupler, LPF & Antenna Relay канала Level UP EE Lab
The directional coupler will allow me to measure forward and reflected RF power, so that I can calculate in the Arduino software the transmitted power and the standing wave ratio (SWR).
No endorsement is made nor implied to any commercial products referenced in this episode.
Видео HF Transmitter #09 - Directional Coupler, LPF & Antenna Relay канала Level UP EE Lab
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
HF Transmitter #08 - The Final Frontier...of Final Power AmpsHeathkit IM-38: RestorationHF Transmitter #17 - RF Pre-Amp AGAIN and Performance TestsHeathkit AV-3: Repair Project - Episode #1Heathkit (Heathbuilt) EUW-15 HV DC Power Supply - Part #3Drake TR-3: Episode #4Hamvention 2023: What Did I Buy??Superhet Receiver Part #2: Final schematic and simulationsHF Transmitter #19 - Captain/Minion and Wrap-UpNon-Contacting High-Speed Multiplexing RF Switch: Part #2Heathkit DX-60: Part #3Superhet Receiver Part #10: All Done!HF Transmitter #16 - The SoftwareHF Transmitter #15 - RF Preamp Trial Number 3Heathkit HW-101 Part #2: Cleaning & InspectionHeathkit IG-102 RF Signal Generator RestorationHF Transmitter #02 - Circuits, Calcs, and Simulations!Heathkit AV-3: Repair Project - Episode #2E. F. Johnson Viking Adventurer Restoration: Part #31,000 Subscribers and a Super-Unboxing-Combo Episode!