MPLS Configuration Step by Step - Cisco MPLS Tutorial CCIE CCNP

✅ Subscribe to my Channel and get more great tips
https://www.youtube.com/rogerperkin/?sub_confirmation=1
Related Blog Post:▶ https://www.rogerperkin.co.uk/ccie/mpls/cisco-mpls-tutorial/

Check out my Network Automation Courses: https://www.rogerperkin.co.uk/courses/

The gear I use everyday: https://www.amazon.co.uk/shop/rogerperkin

In this Cisco MPLS Configuration Step by Step Tutorial I will be setting up a 3 router MPLS core in GNS3 and then add a single site router, peer MP-BGP between R1 & R3 and then create VRF's and OSPF between the site routers.

▶ Timestamps:
00:00 Introduction
00:15 Create the core topology in GNS3
08:00 Enable LDP on all interfaces
10:10 LDP Trace
11:45 Multi-Protocol BGP configuration
13:25 Add customer site routers into topology
17:20 Create VRF's
23:45 Config review and route verifications
25:45 Route redistribution
27:45 Final ping using MPLS across the topology

Check out my Ansible Course :▶ https://bit.ly/ansiblecourse

Ideal preparation for CCNA, CCNP and CCIE Certifications -

More MPLS Configuration Resources
Want to learn more about MPLS? Check out these other great posts on MPLS configuration and troubleshooting.

https://www.rogerperkin.co.uk/ccie/mpls/mpls-ldp-troubleshooting/
This post covers some basic MPLS LDP Troubleshooting commands and how to use them.

https://www.rogerperkin.co.uk/ccie/mpls/route-distinguisher-vs-route-target/
This post covers the difference between the RD & RT values – and no they are no the same thing!

Also referred to as Layer 3 VPN, L3VPN or MPLS VPN this tutorial will take you from a blank router to a fully working Layer 3 MPLS Lab in under 30 minutes.

#cisco #mpls #ccnp

Building the simple MPLS topology below this will consist of a 3 router MPLS core and two remote sites in the same VRF running OSPF as the PE-CE routing protocol. This will be quite a long post as I will be taking you through every single verification along the way to ensure you understand how each section works.

I will be using GNS3 and configuring the routers as we go so you can follow along.

✅ Recommended Playlists:
Python for Network Engineers
https://www.youtube.com/watch?v=DAAYN75kVfw&list=PLplGU0K93TA5QMtutrVEmnV_KyCBqNZ53

Cisco SD WAN Tutorials // Lab Setup on EVE-NG
https://www.youtube.com/watch?v=6En0ECiOwk4&list=PLplGU0K93TA4oi8wcWGUUtdyJP9VNZ5Ce

Ansible for Network Engineers
https://www.youtube.com/watch?v=hLhHZ_uju2Q&list=PLplGU0K93TA6k5L6VX9mYnwgPK5MYe_9c

🔴 Check out my Courses:
https://www.rogerperkin.co.uk/courses/

Follow me on:
Twitter: https://twitter.com/rogernperkin

For professional enquiries contact me via Linkedin
https://www.linkedin.com/in/rogerperkin/

Видео MPLS Configuration Step by Step - Cisco MPLS Tutorial CCIE CCNP канала Roger Perkin