FD3/64 stick mod
FD3/64 hockey stick mod
suggest 5 sticks at first , 10 later but it's going to get very crowded.
with the 10 hole pattern it's 5 or 10 , 5 is minimum but should get you up and running don't think 10 would work/fit..
The sticks will need modifying as suggested but keep them similar to the Mark Drake sticks with a venturi section at the inlet and a spring at the exit.
The coil is 65 mm i/d diameter at the front end which would put it forward of the 4 mm holes so sticks should exit at same position I was wrong on video.
You need to induce some swirl as Kurt intended with the 5 0.8 mm holes in the coil after drilling he used piano wire to alter hole direction.
The sticks could be modified to induce swirl as well as some of the other primary holes could be twisted.not sure which you could try if it makes it worse you can always knock them flat again.
Try to make the outer can removable to be able to repair /modify chamber.
Do let me know if you try it.
Warning do not use cardboard or cardboard derivatives ,paper sellotape or string on any gas turbine or oil tanker ! see video below.
https://www.youtube.com/watch?v=3m5qxZm_JqM
Видео FD3/64 stick mod канала reedy93
suggest 5 sticks at first , 10 later but it's going to get very crowded.
with the 10 hole pattern it's 5 or 10 , 5 is minimum but should get you up and running don't think 10 would work/fit..
The sticks will need modifying as suggested but keep them similar to the Mark Drake sticks with a venturi section at the inlet and a spring at the exit.
The coil is 65 mm i/d diameter at the front end which would put it forward of the 4 mm holes so sticks should exit at same position I was wrong on video.
You need to induce some swirl as Kurt intended with the 5 0.8 mm holes in the coil after drilling he used piano wire to alter hole direction.
The sticks could be modified to induce swirl as well as some of the other primary holes could be twisted.not sure which you could try if it makes it worse you can always knock them flat again.
Try to make the outer can removable to be able to repair /modify chamber.
Do let me know if you try it.
Warning do not use cardboard or cardboard derivatives ,paper sellotape or string on any gas turbine or oil tanker ! see video below.
https://www.youtube.com/watch?v=3m5qxZm_JqM
Видео FD3/64 stick mod канала reedy93
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
FD3/64 turbine blade shaping / grindingSelf Made Jet Engine : Compressor fixkj66/ Kamps Run clip and strip down for bearing change.Hobby jets combustor for the FD/64 finishedFD3/64 Gas Turbine PartsFD3/64 and KJ66 combustion chamberMotor a reacción caseroCombustor Cans 2 - Turbine Engines : A Closer lookFD3/64 gas turbine run up in semi scale Rc Heinkel He 162Umars diffusor assembly part 3!Jet Motoru Yapımı 2 ( Homemade Jet Engine ) Part 2JET ENGINE FD3/64 NGV ALTERNATIVE BUILDFD3/64 Jet turbine wheelFuel handling for micro turbine enginesFD 3/64 repaired and modifiedTaking A Look At The Kurt Schreckling Model Turbine EngineHandmade Jet Engine, Turbine Part 2Tin Can Pulse Jet Powers a Tiny Turbine Wheel !Handmade Jet Engine Almost Finished And First TestTest starter, handmade turbine jet engine