How to Replace Thermostat on a Dodge 5.7L Hemi - P0128 - Challenger Charger Magnum Ram Commander
Thermostat replacement on a 5.7L Dodge Hemi with a P0128 code. The codes states that the thermostat is not opening up all the way or the coolant temperature sensor is bad. Applies to Ram, Challenger, Charger, Durango, Magnum, Commander, Grand Cherokee.
#dodge #p0128 #bundysgarage
Thermostat on Amazon:
https://amzn.to/2SbRc9L
The powertrain control module (PCM) tracks how long it takes for the engine of a vehicle to reach and maintain the correct operating temperature. When the correct engine operating temperature is reached, the powertrain control module orders the fuel system to enter “closed loop” where readings from the oxygen sensors are used to maintain the efficient air to fuel ratio of 14.7:1. Most PCMs mandate that the engine coolant temperature sensor record temperatures above 160º F within 15 minutes of the engine starting. Additionally, once the 160º F threshold is achieved, the recorded engine temperature must not fall below 160º F during operation. The PCM will record if either of these two criteria are not met. If either fault is recorded again on the next engine startup, code P0128 is triggered.
This means that the engine's powertrain control module (PCM) has detected that the engine has not reached the required temperature level within a specified amount of time after starting the engine. Often, the intent of the P0128 code is to indicate a faulty thermostat (likely stuck in the open condition). Similar codes: P0125 In determining that the engine did not reach a "normal" temperature, it takes into account the length of time the vehicle has been running, the intake air temperature (IAT) sensor reading, the engine coolant temperature (ECT) sensor reading, and the speed of the vehicle.
Read more at: https://www.obd-codes.com/p0128
Copyright OBD-Codes.com
More About BundysGarage:
https://goo.gl/qv3Wzc
Questions, Comments, Concerns:
bundysgarage@gmail.com
Twitter:
https://twitter.com/bundysgarage
@bundysgarage
On The Web:
http://www.bundysgarage.com
Music by Randall Kent: As seen on NCIS
https://youtu.be/iYwsjia4GtI
All Rights Reserved 2018
© Copyright 2018
Bundys Garage
All rights reserved. This material may not be published, broadcast, rewritten or redistributed in whole or part with out the express written permission. Contact: bundysgarage@gmail.com
DISCLAIMER - DISCLAIMER - DISCLAIMER
Due to factors beyond the control of BundysGarage, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. BundysGarage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. BundysGarage recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of BundysGarage, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the end user and not BundysGarage nor any of it’s subsidiaries.
Видео How to Replace Thermostat on a Dodge 5.7L Hemi - P0128 - Challenger Charger Magnum Ram Commander канала BundysGarage
#dodge #p0128 #bundysgarage
Thermostat on Amazon:
https://amzn.to/2SbRc9L
The powertrain control module (PCM) tracks how long it takes for the engine of a vehicle to reach and maintain the correct operating temperature. When the correct engine operating temperature is reached, the powertrain control module orders the fuel system to enter “closed loop” where readings from the oxygen sensors are used to maintain the efficient air to fuel ratio of 14.7:1. Most PCMs mandate that the engine coolant temperature sensor record temperatures above 160º F within 15 minutes of the engine starting. Additionally, once the 160º F threshold is achieved, the recorded engine temperature must not fall below 160º F during operation. The PCM will record if either of these two criteria are not met. If either fault is recorded again on the next engine startup, code P0128 is triggered.
This means that the engine's powertrain control module (PCM) has detected that the engine has not reached the required temperature level within a specified amount of time after starting the engine. Often, the intent of the P0128 code is to indicate a faulty thermostat (likely stuck in the open condition). Similar codes: P0125 In determining that the engine did not reach a "normal" temperature, it takes into account the length of time the vehicle has been running, the intake air temperature (IAT) sensor reading, the engine coolant temperature (ECT) sensor reading, and the speed of the vehicle.
Read more at: https://www.obd-codes.com/p0128
Copyright OBD-Codes.com
More About BundysGarage:
https://goo.gl/qv3Wzc
Questions, Comments, Concerns:
bundysgarage@gmail.com
Twitter:
https://twitter.com/bundysgarage
@bundysgarage
On The Web:
http://www.bundysgarage.com
Music by Randall Kent: As seen on NCIS
https://youtu.be/iYwsjia4GtI
All Rights Reserved 2018
© Copyright 2018
Bundys Garage
All rights reserved. This material may not be published, broadcast, rewritten or redistributed in whole or part with out the express written permission. Contact: bundysgarage@gmail.com
DISCLAIMER - DISCLAIMER - DISCLAIMER
Due to factors beyond the control of BundysGarage, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. BundysGarage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. BundysGarage recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of BundysGarage, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the end user and not BundysGarage nor any of it’s subsidiaries.
Видео How to Replace Thermostat on a Dodge 5.7L Hemi - P0128 - Challenger Charger Magnum Ram Commander канала BundysGarage
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
![4 signs of a bad or failing thermostat symptoms and how to check and test](https://i.ytimg.com/vi/GXPUY2y5rgo/default.jpg)
![More than one way to bleed a Hemi coolant system](https://i.ytimg.com/vi/Vw2K8aeLniU/default.jpg)
![](https://i.ytimg.com/vi/FFCp2pzbYUg/default.jpg)
![How to Change the Thermostat on a 06-10 Dodge Charger (Clear and all Steps shown)](https://i.ytimg.com/vi/PCCiXuDf2Jk/default.jpg)
![Jeep Temperature: Thermostat or Sensor Issue](https://i.ytimg.com/vi/gYqmTU3NTgM/default.jpg)
![THERMOSTAT REPLACEMENT - DODGE RAM 1500 HEMI 5.7L](https://i.ytimg.com/vi/zo6lQKAGY0M/default.jpg)
![STEP BY STEP HOW TO REPLACE WATER PUMP IN DODGE CHARG CHRYSLER 300 JEEP RAM 5.7L V8 HEMI FAST & EASY](https://i.ytimg.com/vi/pqxp84i4SUA/default.jpg)
![How to replace Thermostat On Chrysler 300 5.7 Hemi](https://i.ytimg.com/vi/l8zOXQrrBmo/default.jpg)
![Quick Tip: 5.7 Hemi coolant bleeder location and fill procedure](https://i.ytimg.com/vi/l7-cMph3lG8/default.jpg)
![Hemi Coolant Bleeder Location and Fill Procedure](https://i.ytimg.com/vi/j7zz2eq4Au4/default.jpg)
![180 Degree Thermostat Install - Do You NEED a Tune? Budget Mod Series #1](https://i.ytimg.com/vi/hPsODhiQpqU/default.jpg)
![Dodge 5.7 hemi thermostat replacement simple and easy](https://i.ytimg.com/vi/dlGVeyYN4Kc/default.jpg)
![180° Thermostat Installation for Charger R/T](https://i.ytimg.com/vi/CHRQuDMk2fY/default.jpg)
![Thermostat change on a 5.7 Hemi](https://i.ytimg.com/vi/d8Y1ihXFcrA/default.jpg)
![Dodge Charger RT OVERHEATING P2181 fix](https://i.ytimg.com/vi/3BEuNFmU1Do/default.jpg)
![My Challenger KEEPS running HOT!! So I did this...(challenger mod)](https://i.ytimg.com/vi/7-LgRm-4B6Y/default.jpg)
![2012 Dodge Ram 5.7L Hemi - Coolant temperature sensor replacement](https://i.ytimg.com/vi/FdTfADSfbRA/default.jpg)
![[ASMR] EASIEST THERMOSTAT & Drivebelt REPLACEMENT P0128 Dodge Charger 3.6L √ Fix it Angel](https://i.ytimg.com/vi/FM5915ZnDd4/default.jpg)
![Thermostat installation on a 2014 dodge ram 1500 5.7 hemi](https://i.ytimg.com/vi/whbALz2Fi4U/default.jpg)
![5.7 Hemi thermostat replacement](https://i.ytimg.com/vi/cCVzR6YaDIs/default.jpg)