60 Watt Chinese Laser Engraver Water Switch Failure - Leak - Repair

On these Chinese Laser Engraver, if water is flowing through the line to cool down the tube, the LCD panel will read Water Error and not permit function to the Tube. Flow of the water signal is measure by a cheaply made plastic switch installed at the bottom- back-rear right side of the unit, behind the inlet and outlet water connection panel. These switch will eventually leak or crack. You will not find these switch on Ebay, etc... it is best to remove the switch, jump it, remove the water T, directly connect the Laser Tube inlet water line to the Inlet back panel.

Видео 60 Watt Chinese Laser Engraver Water Switch Failure - Leak - Repair канала Matthew Nguyen