How Transistors Work - The Learning Circuit

Karen discusses transistors. Rather than using a physical, mechanical switch, a transistor can act as an electronic switch, using signals to turn it on or off. She'll go over what they are, how they work, and some types of transistors. She covers Bipololar junction transistors (BJT), NPN transistors, PNP transistors, and darlington transistors. Connect with Karen on element14: http://bit.ly/2EASjxT

Visit The Learning Circuit: http://bit.ly/2OIkbEQ

Visit element14 presents: http://bit.ly/2PNXo7d

Visit Project14: http://bit.ly/2PPrjfk

Arduino MKR Giveaways and Livestreams: http://bit.ly/2OF2vKh

Previously, we’ve talked about how diodes work. Silicon diodes have a p-n junction. Bipolar junction transistors or BJTs are bipolar because they have two p-n junctions. BJTs are essentially two diodes in a single package. The two main types are NPN and PNP transistors. NPN transistors have two n-type regions on either side of one p-type region, while PNP transistors have two p-type regions, on either side of one n-type region. Bipolar transistors have 3 leads, one going to each region. Typically, the middle layer is the base. P-type in an NPN, and n-type in a PNP. One of the other layers form the emitter and the third, the collector. These are labelled B, E, and C. On the circuit symbol, the arrow is always on the emitter, so we can tell which lead is the emitter and which is the collector by seeing which one has the arrow. The NPN transistor symbol has an arrow on the emitter pointing out, while the PNP transistor symbol has an arrow on the emitter pointing in. Transistors act as an electronic switch, conducting current across the collector-emitter path when a voltage is applied to the base. The switch is off if there is no base voltage present. When base voltage is present, the switch is on. We know from our diodes lesson, that diodes require a forward voltage of 0.7V before they are turned "on" allowing current to flow. In a standard NPN transistor, when 0.7V is applied between the base and the emitter, the transistor “turns ON”, allowing current to flow from the collector to the emitter. With an NPN transistor, we normally bias the device so that the collector voltage is positive with respect to the emitter. The voltage across these two points is referred to as the Collector-Emitter Voltage or VCE. If you connect the base to be positive with respect to the emitter, the voltage is referred to as the Base-Emitter voltage, or VBE. For a PNP transistor, rather than needing a minimum of 0.7V on the base of the transistor, there needs to be a minimum difference of 0.7V between the VCE, collector-emitter voltage, and VBE, base-emitter voltage. If the circuit power supply is a 9V battery, the base-emitter voltage would need to be no more than 8.3V for the transistor to turn “on” and allow current to flow between the collector and emitter. If the base-emitter voltage is 8.6V, a difference of 0.4V, the transistor would be off and no current would flow. If the base-emitter voltage is 7V, the difference of 2V is greater than 0.7V so the transistor would be “on”, allowing current to flow between the emitter and collector.

Видео How Transistors Work - The Learning Circuit канала element14 presents