Vibrating Shuttle Bobbin Winders

This one goes out to viewer Megan in far away New Zealand. Everything you wanted to know about vibrating shuttle bobbin winders, plus a field expedient repair of a commonly broken part that is no longer available new.

00:00 Introduction and opening titles
01:28 Tools needed and disassembly - remove the belt guard
03:00 Let's compare the Model 27 and Model 127 winders
05:10 Remove the thread guide/cam follower
06:35 Remove the main gear and cam
08:19 Reassembly sequence - Main gear and cam
09:12 A word about the staked on parts on the main casting...
11:25 Dealing with a rusted/gunked up main shaft + a little trick
12:55 Back to reassembly - Installing the main gear and cam
14:19 Work holding
15:40 Installing the thread guide/cam follower and spring
17:00 Checking alignment
18:07 In case you didn't read the manual...
18:30 Finishing the assembly
19:55 Some minor differences
20:39 A common broken part, let's fix it
24:59 A Grinder And Paint...
25:36 Let's test wind a bobbin
26:35 Success!
26:56 Model 27 and Model 127 parts interchangeability
29:41 Free Westinghouse bobbin winder
30:54 Final thoughts

Tools used for R&R of bobbin winder:
Chapman screwdriver with #95 bit or equivalent
9/32" ignition wrench or small adjustable wrench
7mm Nut driver

My website: https://bobsvsmservice.com/

Get a coffee mug! The world is so much better with coffee...
https://bobs-vsm-service.creator-spring.com/

Видео Vibrating Shuttle Bobbin Winders канала Bob Fowler