DIY Livescope Rotating Mount Build

Ok so here is a step by step guide on how I built the rotating mount for my Panoptix Livescope. This was done with parts that are readily available at home improvement stores. Having the rotating mount like this is key to make full use of the Livescopes potential. Total cost for this build is $25.00. All parts used listed below.

Outer PVC Pipe- https://www.lowes.com/pd/Charlotte-Pipe-1-in-x-5-ft-450-Schedule-40-PVC-Pipe/3133093

Inner Pipe- https://www.lowes.com/pd/Silver-Line-Plastics-3-4-in-x-2-ft-160-PSI-Plastic-Coil-Pipe/1000170901

Outer Pipe T Fitting- https://www.lowes.com/pd/LASCO-90-Degree-PVC-Sch-40-Tee/1067669

Inner Pipe Top Fitting- https://www.lowes.com/pd/Genova-3-4-in-Dia-Insert-Male-Adapter/3455128

Inner Pipe Lower Fitting- https://www.lowes.com/pd/Genova-3-4-in-Dia-Insert-Plug/3456480

Rotating Knob Fitting- https://www.lowes.com/pd/LASCO-1-in-x-3-4-in-x-PVC-Sch-40-Bushing/3371588

Rotating Knob Cap- https://www.lowes.com/pd/LASCO-1-1-2-in-x-PVC-Sch-40-Cap/3371576

1.5 Inch Ram Ball Fitting- https://www.rammount.com/part/RAP-294U

Видео DIY Livescope Rotating Mount Build канала Southern Reels Fishing