Meet the INJECTINATOR! (How injection molding of plastic works)

🚀 Next video you should check: https://youtu.be/RfJkn1YqVnI

🔗 Links mentioned in the video:
➡️ SYSTEM8 website: https://www.modable.eu/

👉 Follow me on Threads: https://www.threads.net/@tomazzaman
👉 Follow me on Instagram: https://www.instagram.com/tomazzaman/

====================================================
Video gear I use to make these videos:
- Camera: Sony a7 IV (https://amzn.to/48Vj9L9)
- B Camera: Sony a6400 (https://amzn.to/3QhgkwB)
- Lens: Sony 20mm f1.8 (https://amzn.to/48Vj9L9)
- B Lens: Sony 16-55mm f2.8 (https://amzn.to/3Qg69si)
- Key Light: Amaran 100D (https://amzn.to/3Qhy2PF)
- Modifier: Aputure Light Dome SE (https://amzn.to/45yBDyi)
- Top Light: Falcon Eyes RX-18TD (https://amzn.to/3RWmgfX)
- Fill Light: Amaran T4c (https://amzn.to/3s03sln)
- Kicker Light: Amaran B7c (https://amzn.to/4943Sro)

Audio Gear:
- Mic: Neumann KM185 (https://www.thomann.de/intl/neumann_km185_mt.htm)
- Preamp: Grace Design m101 (https://www.thomann.de/intl/grace_design_m101_preamp.htm)
- Interface: RME Babyface Pro FS (https://www.thomann.de/intl/rme_babyface_pro_fs.htm)

(Disclaimer: some links may be affiliate so I make a tiny kickback from your purchase at no additional cost to you)

Видео Meet the INJECTINATOR! (How injection molding of plastic works) канала Tomaž Zaman