Setup of the Flasks - Video 2
How to prepare the injection waxes by attaching them to the sprue bases. This is how I do it.
***Also notice I included one X-One resin. While I know little about resin this type from BlueCast has actually worked on occasion so I am eager to try it again.
Видео Setup of the Flasks - Video 2 канала Craig Dabler - The DIY Castings Guy
***Also notice I included one X-One resin. While I know little about resin this type from BlueCast has actually worked on occasion so I am eager to try it again.
Видео Setup of the Flasks - Video 2 канала Craig Dabler - The DIY Castings Guy
Показать
Комментарии отсутствуют
Информация о видео
25 июня 2022 г. 5:07:53
00:04:59
Другие видео канала
Two Ways to Fill the Pits on a Sterling Silver Band
Separation of the Mold - Video 2
Sand Casting 1 1/2 Ounces of Sterling Silver - Vacuum Assist Flask Setup
How to Size a Wax for Carving
Sand Casting a Large Butterfly Wing with Petrobond
Video 2: Forming the Paws
Preparing the Mold for Wax Injection: Video Three
Finishing a Stone in Place Ring
Using a plastic flower Craig Dabler sand casts it in sterling silver.
Steaming the Flask - Video 5
How to Cut a Bench Pin to File Inside Rings
Basic Wax Band Carving
Sand Casting a New Paw Pattern
Make Your Own Wedding Band - Sand Casting!
Emma Putting Together a Premium Kit and Using it
Introducing, The New 3 Inch Sand Casting Flask by Craig Dabler
Opening the Toaster Oven Vulcanized Mold: Video Two
Mold Making - Powder Separation - Experiment
The Dangers of Using Propane Indoors - Video 8
Using the Toaster Oven Rubber Mold