Making a Custom Brass Nut and Bolt on the Mini Lathe out of Hex Stock

This video is how to make a simple nut and bolt out of brass hex stock on the MINI LATHE. (MUCH) More information below!

Please like and subscribe if this was helpful!

Stuff from this video:
Tap and Die Set: http://amzn.to/2pBk6SB

Lathe: https://amzn.to/2nVBrEc

Stuff on the lathe:
Quick Change Tool Holder: https://amzn.to/2oZtFee
Tailstock Drill Chuck: https://amzn.to/2pmE0jX

Lathe tools:
Boring Bar: https://amzn.to/2pmy0b1
Carbide Tools: https://amzn.to/2oRZWax
Parting Tool: https://amzn.to/2nVCeW1
Center Bits: https://amzn.to/2oRRV5n
Drill Bits: http://amzn.to/2oz9W76

Other stuff:
Cutting oil: http://amzn.to/2ofkPaY

Mini Lathe troubleshooting guide: http://littlemachineshop.com/reference/drivetroubleshooting.pdf

Controller board wiring configuration: http://imgur.com/KIEzu92

The real version of the motor controller: https://amzn.to/2orw43F
Datasheet for the KBIC-120: https://www.galco.com/buy/KB-Electronics/KBiC-120

Super nice guy who repairs the controller boards: http://olduhfguy.com/

Music:
https://www.youtube.com/watch?v=YJKpnmZdAoE

Adventures by A Himitsu https://soundcloud.com/a-himitsu
Creative Commons — Attribution 3.0 Unported— CC BY 3.0
http://creativecommons.org/licenses/b...
Music released by Argofox https://youtu.be/8BXNwnxaVQE
Music provided by Audio Library https://youtu.be/MkNeIUgNPQ8

Видео Making a Custom Brass Nut and Bolt on the Mini Lathe out of Hex Stock канала TimNummy