The press brake bending you might have never seen before

A press brake is a machine tool for bending sheet and plate material, most commonly sheet metal. It forms predetermined bends by clamping the workpiece between a matching punch and die.

In general, press brake die can be divided into the upper die, the lower die, guide rail, lower die base etc. These dies have a wide range of versatility, most of them can be fabricated.

The different die should be used for fabricating different workpiece. You need to know the fabrication parameters of press brake machine as well as the die very well, then it is possible for you to choose the right press brake die to match each other.

Press brakes toolings material: Cr12Mo1v1,42CrMo, T10a

Hardening: HRC: 52 ° -60 °
Tolerance: ±.002
Standard length: 835mm, 800mm, 550mm
(Standard press brake toolings in stock, non - standard bending machine mold can be customized according to customer drawings)

The dies including: offset die, concentric lower die, upper die, lower die, composite forming mold, etc.

The selection of press brake toolings mainly adopts T8, T10 steel, and some better material such as 42CrMo. 42CrMo is a high strength alloy quenched and tempered steel, with high strength and good toughness, can work below 500 degrees. It requires high strength, high toughness and good wear resistance.

If you want to learn more about press brake dies, you can check out this article:
Press brake dies: the ultimate guide: https://www.machinemfg.com/press-brake-dies-guide/

About press brake, check this article:
https://www.machinemfg.com/press-brake-ultimate-guide/

And if you need to purchase one press brake machine, you can visit this page:
https://www.artizono.com/press-brake/

Видео The press brake bending you might have never seen before канала Artizono