3D LabPrint F 86 Sabre V2 Maiden Flight

Chris flies his second print of the F-86 Sabre. A couple months ago, the first one suffered a mid air wing separation and went in hard. This aircraft uses all of the previous components from the wreck except for the ESC.

Flying on his wing is a Freewing F-86 Sabre from Motion RC. I bought it when it was first released back in 2014. It had well over 200 flights on it before it left my hangar and went to Greg a couple years ago. It has a genuine patina. It must have nearly 400+ flights on it and I believe it has only required a nose gear repair in all that time!

Thx to both gents piloting their aircraft for the camera today. This was filmed at FLY-A-WAYS Club air field, North Plains Oregon.

3D LabPrint F-86 Sabre: Chris
Freewing F-86 Sabre: Greg Menton

Camera: Dennis Wright

music bensound.com

© 2020 by WBRC. All rights reserved. No part of this video may be reproduced or transmitted in any form or by any means, electronic or mechanical, without the written permission of the copyright holder.

Видео 3D LabPrint F 86 Sabre V2 Maiden Flight канала WrightBrosRC