Knotting Process of a loom I Fischer poege Machines I

Here is the intro of knotting & a guide :-
This project is mainly revolves around the process of knotting in the loom shed which is primary process to run the loom satisfactorily. Better quality of knotting ensures the better performance of loom with respect to minimum end breakages which leads to cause improvement in efficiency. Warp knotting is the process of tying the warp sheets at the time of beam change. For tying of two warp sheets it takes some time and affect on loss of loom efficiency so that this time should be optimum.
The automatic knotting machines can process a wide range of yarn types and counts at highly reliable and rapid operating conditions (up to 600 knots/minute), with mechanical or electronic control on double knots and on the sequence of warp patterns in case of multi-coloured warps.
Quality of knot:
1. Strength of the knot should be enough sufficient that it should withstand the stresses and strain during weaving and it should not be slipped.
2. The size of the knot should be as minimum as possible since that it should pass through the heald eyes, reed dents.
3. The tail length of knot should be less about 1-2mm hence that it should not cause entanglement with another end.
By improving quality in terms of reducing cross end, double end it reduce the fault occurred due to this problems and improving the quality of warp knotting as well as warp knotting to the single end means there is no double end warp knotting and hence it reduces the time during warp knotting when this double end fault corrected.
#knottingmachine #knottingtechniques #knottingtutorial #knottingprocess #textile #review #production

Видео Knotting Process of a loom I Fischer poege Machines I канала Apna 31