How to Install a Self-Watering Garden | Ask This Old House

Ask This Old House landscape contractor Roger Cook shows a homeowner in Orlando how to plant a low-maintenance vegetable garden using hydroponics.
SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse

Time: 5 hours

Cost: $700

Skill Level: Moderate

Tools List for Installing a Self-Watering Garden:
Rubber Mallet
Torpedo Level
Irrigation punch tool

Shopping List:
Hydroponic garden kit
Weed barrier
Landscape staples
Perlite
Coconut Fiber
32 gallon trash can
Plug in timer

Steps:
1. Vegetables thrive in full sunlight, so choose a sunny location.
2. Lay down a layer of weed barrier with landscape staples.
3. Drive support rods into the ground one foot using the rubber mallet. Ensure they stay plumb with the torpedo level.
4. Drive the support column into the ground over the support rods, sinking it 10” into the ground. Use a bolt to ensure the end of the column isn’t damaged.
5. Slide the lower planter over the support column. Add two spacers, then the support for the next planter.
6. Add the column extension to reach the final height of the system.
7. Before planting in the upper planters, use a scrap piece of pipe to cover the holes.
8. Fill the container _ with perlite and _ with coconut fiber.
9. Add plants to the corners of the planters, covering with coconut fiber.
10. Fill the lower planter with the same mix and plant with larger crops like broccoli.
11. Drop each square planter onto the column, keeping each level at opposing angles.
12. Add a small pot for the irrigation system to the top of the column, then a piece of black tubing, and finally a PVC tee fitting with a hole drilled in it for the spaghetti irrigation line. Hold the spaghetti line in place using the black tubing.
13. Run a main irrigation line between all four planter columns.
14. Drill a hole in the lid of the 32 gallon trash can. Slide the irrigation line into that hole and attach it to the submersible pump. Ensure the power line runs out of the trash can.
15. Attach the line from the pump to the main irrigation line.
16. Use a punch tool to pierce the main irrigation line and attach the spaghetti tubing to that line.
17. Plug the timer into a wall outlet, then plug the pump into that. Set the pump to run a few times a day.
18. Fill the trash can with water and add the nutrients as prescribed by the manufacturer.

Resources:
Roger visited the Orange County Extension Education Center (http://sfyl.ifas.ufl.edu/orange/) in Orlando, Florida to see some inspirational gardens.

Roger installed the VGK-16AGP vertical garden system, manufactured by Verti-Gro (http://www.vertigro.com/Default.asp)

About Ask This Old House TV:
Homeowners have a virtual truckload of questions for us on smaller projects, and we're ready to answer. Ask This Old House solves the steady stream of home improvement problems faced by our viewers—and we make house calls! Ask This Old House features some familiar faces from This Old House, including Kevin O'Connor, general contractor Tom Silva, plumbing and heating expert Richard Trethewey, and landscape contractor Roger Cook.

Follow This Old House and Ask This Old House:
Facebook: http://bit.ly/ThisOldHouseFB
Twitter: http://bit.ly/ThisOldHouseTwitter
http://bit.ly/AskTOHTwitter
Pinterest: http://bit.ly/ThisOldHousePinterest
Instagram: http://bit.ly/ThisOldHouseIG
http://bit.ly/AskTOHIG
Tumblr: http://bit.ly/ThisOldHouseTumblr

For more on This Old House and Ask This Old House, visit us at: http://bit.ly/ThisOldHouseWebsite

How to Install a Self-Watering Garden | Ask This Old House
https://www.youtube.com/user/thisoldhouse/

Видео How to Install a Self-Watering Garden | Ask This Old House канала This Old House