SPIM08HP Lithium Polymer Pouch Cell 20Amp Load Test (2.5C)
Use code “DIY” for 10% off at Battery Hookup!
Do these 200A rated cells hold up at 20A? I aimed for testing at 3C (24Amp) but ended up with more like 2.5C in this test. I was happy with the results for what I plan to use the batteries for. I explain the test setup I'm using to determine the capacity and rate of discharge and pontificate on the results at the end.
Supplies:
Single SPIM08HP cells: https://bit.ly/2Ax1iib
10 Pack of SPIM08HP Batteries: https://www.batteryclearinghouse.com/products/3-7v-8ah-200a-lithium-ion-power-spim08hp
72 Pack of SPIM08HP Batteries:https://www.batteryclearinghouse.com/products/100-pack-3-7v-8ah-200a-lithium-ion-power-spim08hp
Watt Meter: https://amzn.to/3dK2DRL
SkyRC iMAX B6AC V2 Charger: https://amzn.to/3c2VytZ
DC Motor Speed Controller: https://amzn.to/2UVqchP
Some other parts I used for building a pack out of these cells:
BMS Protection Board for battery: https://amzn.to/2X5jnNu
XT60 connectors, wiring, and heatshrink: https://amzn.to/2UDSnTF
M6x8 screws for bolting battery tabs together: https://amzn.to/3aDIY43
Washers for bolting battery tabs together: https://amzn.to/34c6xOP
Nuts for bolting battery tabs together: https://amzn.to/343gj5U
Heat resistant tape for holding battery together: https://amzn.to/2JyT6Pp
As an Amazon Associate I earn from qualifying purchases.
As a Battery Hookup affiliate I earn from some purchases made through links on this page.
While children may find this video entertaining, it is not intended for children under the age of 13.
#homesteading #DIY
Видео SPIM08HP Lithium Polymer Pouch Cell 20Amp Load Test (2.5C) канала Beene Energy
Do these 200A rated cells hold up at 20A? I aimed for testing at 3C (24Amp) but ended up with more like 2.5C in this test. I was happy with the results for what I plan to use the batteries for. I explain the test setup I'm using to determine the capacity and rate of discharge and pontificate on the results at the end.
Supplies:
Single SPIM08HP cells: https://bit.ly/2Ax1iib
10 Pack of SPIM08HP Batteries: https://www.batteryclearinghouse.com/products/3-7v-8ah-200a-lithium-ion-power-spim08hp
72 Pack of SPIM08HP Batteries:https://www.batteryclearinghouse.com/products/100-pack-3-7v-8ah-200a-lithium-ion-power-spim08hp
Watt Meter: https://amzn.to/3dK2DRL
SkyRC iMAX B6AC V2 Charger: https://amzn.to/3c2VytZ
DC Motor Speed Controller: https://amzn.to/2UVqchP
Some other parts I used for building a pack out of these cells:
BMS Protection Board for battery: https://amzn.to/2X5jnNu
XT60 connectors, wiring, and heatshrink: https://amzn.to/2UDSnTF
M6x8 screws for bolting battery tabs together: https://amzn.to/3aDIY43
Washers for bolting battery tabs together: https://amzn.to/34c6xOP
Nuts for bolting battery tabs together: https://amzn.to/343gj5U
Heat resistant tape for holding battery together: https://amzn.to/2JyT6Pp
As an Amazon Associate I earn from qualifying purchases.
As a Battery Hookup affiliate I earn from some purchases made through links on this page.
While children may find this video entertaining, it is not intended for children under the age of 13.
#homesteading #DIY
Видео SPIM08HP Lithium Polymer Pouch Cell 20Amp Load Test (2.5C) канала Beene Energy
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Megarevo R8KLNA Idle ConsumptionLIVE - Evening Battery Build and TalkPutting Them To UseLIVE: Getting on the JK BMS BandwagonBackup Load Center PrioritiesHow New Solar Panels Can Be Less Expensive Than UsedMegarevo Improving Inverter EfficiencyCold Panel Better Than Clean Panel?Huawei Inverter CommissioningDirty Solar PanelsAC coupling a Schneider to EnphaseClassic BMS Choice For 16s LiFePo4 Battery PackAvoiding 30 Cents Per KWH Without A Sol-ArkShorting My Megarevo Like Blockbuster Stock340W Heliene Solar PanelsBatteryless With Grid SupplementsDitching Deck Screw Mounts on my Solar ArrayReplacing the Achilles HeelDragging panels out to test200W CIGS From SoloPower - Performance Data1 More Year Of Production In The Books