How to Tune-Up & Properly Service the Mantis Tiller 2 Cycle ~ Do this to Save Your Machine

NOTE: !!!! Readme
The GASKET/DIAPHRAGM ORDER IS CORRECT!
The video isn't wrong. I have tested it both ways, It WONT RUN any other way!
This is because it is a Primer Bulb / Fuel Pump Combination. The body of the primer bulb has ports on it that require a gasket to seal it, the diaphragm isn't thick enough to seal it and the tang (bump) that pushes on the needle fulcrum wont reach.
The diaphragm must seat to the machined surface as its very thin. The little bump on it can now actuate the fulcrum.
What others have commented on is correct for carburetor setups that use the steel plate to hold the diaphragm on, this is not the case / application here.

Do this to Save your Machine.
I show an older machine that died from lack of Service!
If you don't do these things you are Killing Your Machine!

Lets go over the machine, rebuild the carburetor and fuel system
New Fuel lines
Then I go over maintenance & lubrication to the Transmission!!!

HIPA Fuel Bulb Part number
X00XDNR1T
Or search your model - You can also measure your bulb. (only 2 sizes)

Intro 0:00
Carburetor & Tank Removal 1:17
Carburetor Teardown & Rebuild 3:55
Fuel Tank / Hose Info &i Installation 10:15
Carburetor Installation 20:30
Testing 26:52
Misc., Lubrication and adjustments 30:56
Transmission Lubrication 33:10
What Happens when Its Not Lubricated 37:32
How to Set the Tines for different jobs 39:48
Outro 44:15

Видео How to Tune-Up & Properly Service the Mantis Tiller 2 Cycle ~ Do this to Save Your Machine канала Arch's Garage