FlySky FS-i6X How to Setup Flaperons - 2-Position Flaperons mix with i6X and iA6B Rx Tutorial Guide

Want flaperons on your airplane? Me too! In this video I'll show you how I set up two-position flaperons on the Flysky FS-i6X radio and FS-iA6B receiver.
It's a bit of a process, but I think the end result is pretty sweet. (If you know of a simpler way, please let us know!)

FS-i6X: https://amzn.to/2W2CfNH

In case you don't need the step-by-step version, I've written down the key info below (let me know if you find something that doesn't make sense!):

********FS-i6X FLAPERONS SETUP GUIDE:*********
👉 Remove propeller(s)
👉 Bind tx/rx (if not already done)
👉 Plug servo into Ch1
👉 Plug other servo into Ch5 (or whichever open servo channel you want to use. For this example I'm using channel 5) (my servos are each pointing out away from the fuselage)
👉 Reverse Ch1 SERVO as needed to achieve normal aileron movement for that servo. (roll right, control surface goes up) HOLD CANCEL TO SAVE.
👉 Turn on Aux Channels (in system settings menu) . HOLD CANCEL TO SAVE.
👉 Set Ch7 (AUX 7) to SW C (the 3-position switch). HOLD CANCEL TO SAVE.
👉 Make sure Ch5 SOURCE is set to NONE (because that's the channel for the servo)
👉 👉 Set MIX 1 (Ch1 controls ch5) (this mix is to make the servos function as normal ailerons)
Master: Ch1
Slave: Ch5
Pos. Mix: -100%
Neg. Mix -100%
Offset: 0%
👉 👉 Set MIX 2 (Ch 7 Controls Ch1)
Master: Ch7
Slave: Ch1
Pos. Mix: -40%
Neg. Mix: -40%
Offset: -15%
👉 👉 Set MIX 3 (Ch7 controls Ch5)
Master: Ch7
Slave: Ch5
Pos. Mix: -40%
Neg. Mix: -40%
Offset: -15%
👉 Hold CANCEL to SAVE
👉 Check for correct movement
👉 Adjust percentages as needed to make physical aileron deflection and neutral positions match each other
👉 Done
👉 Set up other control surfaces, failsafe, throttle hold, etc. as needed.
👌
* * * * * * * *
Hope this helped!
Amazon https://amzn.to/2FHjkwI
Banggood https://www.banggood.com/custlink/KvmDJdaqrC
I have a website http://rcwithadam.com/
-------
MY GEAR

RADIO: https://amzn.to/2osIur0 https://www.banggood.com/custlink/3KvvWylkJ0
QUAD RECEIVER: https://amzn.to/2CsvX0C https://www.banggood.com/custlink/v3vDJYjMWs
AIRPLANE RECEIVER: https://amzn.to/2OBIqnj https://www.banggood.com/custlink/GG3vryakFJ
QUAD PROPS (my fav) https://amzn.to/2DywVXA https://www.banggood.com/custlink/GGKGpRjkJz

FILMING GEAR
Main camera https://amzn.to/2pGZA4L
Mic https://amzn.to/2OKoCOB
Camera stand https://amzn.to/2C4I3uX

--------
Mandatory Disclaimer:
I participate in the Amazon Affiliates program, which means that if you click on one of the above Amazon links and purchase a product on Amazon, I will receive a teeny tiny commission (at no additional cost to you). Also, various other links listed here may be affiliate links, to which this disclaimer also applies.
**REMEMBER, always use caution and your best judgement when building and flying RC aircraft, be a good neighbor, and HAVE FUN!**
-----------
About this channel: Adam makes FUN and HELPFUL videos about building and flying Radio Controlled aircraft, tech, and DIY projects!

Видео FlySky FS-i6X How to Setup Flaperons - 2-Position Flaperons mix with i6X and iA6B Rx Tutorial Guide канала RCwithAdam