Jewelry Making PART 3: Everything was going well... and then I FAILED.
Welcome to Part 3 of the jewelry making series! If you haven't checked out part 1 or 2, here they are:
Part 1: https://youtu.be/KBsT6-mt5rY
Part 2: https://youtu.be/gbHHGKuTdV0
In this video everything was going great.... and then, I messed up. I was making a heart shaped pendant with gemstones down both sides, and everything went great until I started making the holes for the gemstones... There were a lot of factors on why it failed.... should have had my workpiece held more securely, should have had the right set of burrs, should have focused more.... there are a lot of things I could say, but in the end it is what it is... Sometimes is better just to know when you're beat and stop trying to correct the problem. Just scrap it and start over... and that's what I did. Be sure to check out the next video, when I create something new and redeem myself!
Видео Jewelry Making PART 3: Everything was going well... and then I FAILED. канала Reese Customs
Part 1: https://youtu.be/KBsT6-mt5rY
Part 2: https://youtu.be/gbHHGKuTdV0
In this video everything was going great.... and then, I messed up. I was making a heart shaped pendant with gemstones down both sides, and everything went great until I started making the holes for the gemstones... There were a lot of factors on why it failed.... should have had my workpiece held more securely, should have had the right set of burrs, should have focused more.... there are a lot of things I could say, but in the end it is what it is... Sometimes is better just to know when you're beat and stop trying to correct the problem. Just scrap it and start over... and that's what I did. Be sure to check out the next video, when I create something new and redeem myself!
Видео Jewelry Making PART 3: Everything was going well... and then I FAILED. канала Reese Customs
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Building a Custom Oak deskJekyll Island Off the beaten pathYou NEED to watch this before using Resin!Best way to fill a round hole #diy #woodworkingTiller rescue. Will it run after 20 years?Making a Micarta and Mica powder ring (Highlights video!)Antique table repair without damaging finish! NO Sanding requiredSuper Easy DIY Hydro DippingBuilding a WOODEN Clock!Free John Deere lawnmower. Will it RUN again?Is your tape measure accurate???How to Stabilize wood for resin casting....... With a Giveaway!!Building beautiful furniture from PINECUSTOM oak countertop. FULL build videoCUSTOM Oak countertop, quick build videoBuilding this custom, Vintage wood and metal sign!!!Easily replicate any part with Silicone!I blame the whiskey drinkers for this... #whiteoak #whiskey #wood #woodworking #furnituremakingJewelry Making PART 1. Casting a silver ingotBuild Cabinet doors like a PRO!!