7 Best And WEIRDEST Ways To FIND A STUD (#7 is the strangest!)
AFFILIATE LINKS FOR THIS VIDEO:
Applied Magnets 10 Rare Earth Neodymium:
http://bit.ly/Applied10raremagnets
15-Pack Rare Earth Disc Magnets:
http://bit.ly/15RareDiscMags
Phillips Norelco Travel Razor:
http://bit.ly/PhillipsTravelRazor
Estwing 16 oz. Hammer:
http://bit.ly/EstwingHammer160z
Steel Wool 12-Pad Super Fine:
http://bit.ly/SteelWool12Superfine
THERE ARE ACTUALLY 8 METHODS IN THIS VIDEO due to a small editing fiasco. MORE IS ALWAYS BETTER THOUGH, RIGHT?! :)
Who needs a studfinder? These 8 ways to find a stud are the best and the weirdest! Here at The Honest Carpenter, we personally think #3 is the best, but #7 is the weirdest method that REALLY WORKS!!
BE SURE TO CHECK OUT OUR OTHER VIDEOS:
World's Greatest Tool Belt:
https://youtu.be/PjhDD2k8v5c
Chisel Vs. Big Screwdriver:
https://youtu.be/C_VAbZFAtaE
Don't Use A Ball Catch Latch!:
https://youtu.be/3idyE94Dohw
There are a lot of ways to find a stud. But these are the ones that I use as a professional carpenter, plus a couple weird ones thrown in!
8 WAYS TO FIND A STUD:
1: The Knocking Method: Use a 16 oz. hammer wrapped in a wash cloth to knock on the wall. The space between studs will make a low pitch sound. The point on studs will make a higher pitch sound.
2: The Electric Razor Method: Battery-powered electric razors also work well. Press them to the wall and move the sideways. Vibrations will make a higher-pitched sound on studs.
3: Use Magnets! : This is by far the best method. I use rare earth neodymium magnets to find screw heads where drywall is attached to studs.
4: Look For Outlets And Lightswitches: These electrical boxes are almost always mounted to studs. Just knock on the wall to either side of the outlet.
5: Look For Nails In Trim: Carpenters mostly try to nail trim to studs for better support. Look for trim nails that painters did not effectively hide, then test the wall with a magnet.
6. Look For Popped Screws: Drywall screws that don't get set deeply enough sometimes pop their mud patches. Use a bright light held near the wall to make them stand out visibly.
QUICK TIP: Remember that studs are spaced 16" on-center, except in some newer homes where they are spaced 24" on-center.
6 (b): The Coathanger Method: Straighten a wire coathanger, then put a crook partway down. Punch a dime-sized hole in the wall. Feel the coathanger through and swing it around until it hits a stud. Pull the coathanger out at that angle and hold it up to the hole in the wall. You'll be able to see the approximate stud location.
#7: The Steel Wool Method: Rub two pads of steel wool together near the wall. The friction between metal surfaces will produce a small electrical charge. Filaments with this charge will fall down the wall and get stuck on screw heads magnetically. These are your stud locations.
Thanks for watching! PLEASE BE SURE TO LIKE AND SUBSCRIBE FOR MORE VIDEOS!
Also, be sure to visit us at The Honest Carpenter Website:
www.thehonestcarpenter.com
Видео 7 Best And WEIRDEST Ways To FIND A STUD (#7 is the strangest!) канала The Honest Carpenter
Applied Magnets 10 Rare Earth Neodymium:
http://bit.ly/Applied10raremagnets
15-Pack Rare Earth Disc Magnets:
http://bit.ly/15RareDiscMags
Phillips Norelco Travel Razor:
http://bit.ly/PhillipsTravelRazor
Estwing 16 oz. Hammer:
http://bit.ly/EstwingHammer160z
Steel Wool 12-Pad Super Fine:
http://bit.ly/SteelWool12Superfine
THERE ARE ACTUALLY 8 METHODS IN THIS VIDEO due to a small editing fiasco. MORE IS ALWAYS BETTER THOUGH, RIGHT?! :)
Who needs a studfinder? These 8 ways to find a stud are the best and the weirdest! Here at The Honest Carpenter, we personally think #3 is the best, but #7 is the weirdest method that REALLY WORKS!!
BE SURE TO CHECK OUT OUR OTHER VIDEOS:
World's Greatest Tool Belt:
https://youtu.be/PjhDD2k8v5c
Chisel Vs. Big Screwdriver:
https://youtu.be/C_VAbZFAtaE
Don't Use A Ball Catch Latch!:
https://youtu.be/3idyE94Dohw
There are a lot of ways to find a stud. But these are the ones that I use as a professional carpenter, plus a couple weird ones thrown in!
8 WAYS TO FIND A STUD:
1: The Knocking Method: Use a 16 oz. hammer wrapped in a wash cloth to knock on the wall. The space between studs will make a low pitch sound. The point on studs will make a higher pitch sound.
2: The Electric Razor Method: Battery-powered electric razors also work well. Press them to the wall and move the sideways. Vibrations will make a higher-pitched sound on studs.
3: Use Magnets! : This is by far the best method. I use rare earth neodymium magnets to find screw heads where drywall is attached to studs.
4: Look For Outlets And Lightswitches: These electrical boxes are almost always mounted to studs. Just knock on the wall to either side of the outlet.
5: Look For Nails In Trim: Carpenters mostly try to nail trim to studs for better support. Look for trim nails that painters did not effectively hide, then test the wall with a magnet.
6. Look For Popped Screws: Drywall screws that don't get set deeply enough sometimes pop their mud patches. Use a bright light held near the wall to make them stand out visibly.
QUICK TIP: Remember that studs are spaced 16" on-center, except in some newer homes where they are spaced 24" on-center.
6 (b): The Coathanger Method: Straighten a wire coathanger, then put a crook partway down. Punch a dime-sized hole in the wall. Feel the coathanger through and swing it around until it hits a stud. Pull the coathanger out at that angle and hold it up to the hole in the wall. You'll be able to see the approximate stud location.
#7: The Steel Wool Method: Rub two pads of steel wool together near the wall. The friction between metal surfaces will produce a small electrical charge. Filaments with this charge will fall down the wall and get stuck on screw heads magnetically. These are your stud locations.
Thanks for watching! PLEASE BE SURE TO LIKE AND SUBSCRIBE FOR MORE VIDEOS!
Also, be sure to visit us at The Honest Carpenter Website:
www.thehonestcarpenter.com
Видео 7 Best And WEIRDEST Ways To FIND A STUD (#7 is the strangest!) канала The Honest Carpenter
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
11 DRILLING TIPS AND TRICKS (And Mistakes To Avoid!)😳👉 Using a Stud Finder, correctlyWhich Drywall Anchor is Best? Let's find out!You Only NEED 2 POWER TOOLS!! (Here's What They Are...2 MOST IMPORTANT Power Tools)Fix Rotted Door Frame (Brickmold)Door Won’t Latch—3 Easy Fixes!Everything You Need to Know About Wall PlugsDRILL VS. DRIVER (What's The Difference?!! Cordless Drill Vs. Impact Driver--COMPARISON)Best Stud Finder? $262 Bosch vs $10 CH Hanson vs 9 Other Wall Stud Scanners! Let's find out!5 WAYS CONTRACTORS CHEAT THEIR CLIENTS! (Don't Let This Happen!! HOMEOWNERS SHOULD WATCH...)IS THIS THE MOST USEFUL TOOL IN THE WORLD? Watch And Decide!! (5-In-1, 6-In-1,Painter's Tool)The Stud Finder Showdown - Which One Is Best?PVC TRIM VS. WOOD TRIM? (Pros And Cons!)6 Step Ladder Tricks And Secrets (#4 Saves Major HEADACHES!)Easy Drywall Tricks to Fix Any MistakeThis May be the Best Stud Finder...10 Tape Measure Tricks & TipsHow To Repair Rotted Door JambsUSE THIS WEATHERSTRIP ON OLD DOORS! (Save $$, Prevent Cold Air Drafts / BEST DOOR WEATHERSTRIPPING)MDF VS. PLYWOOD (Which Is Better?? Pros + Cons!!)