Creality Ender 3 V2 - Stop Stringing, Improve Print Quality & Time With These Two Settings

It can always be better! When you are making 3D prints to sell, less cleanup = more time. Less cleanup also means better looking prints as well. In this video I review one standard method of preventing stringing and one not-so-standard method so that you can produce better quality 3D prints right off of the build-plate.

Recently switching from the Anet A8 printer to the Creality Ender 3 V-3, I knew there were some settings that would need to be adjusted, I did not realize the retraction distance would be so different. Along with settings to correct the retraction distance, I also wanted to see if I could further improve the print quality so I could reduce the cleanup required to nearly zero. With this type of print, there is a feature buried in Cura to do just that and I show you in this video where to find it and what it does.

These two settings have taken my print quality to the next level and I couldn't be happier.

This is where I bought the printer, at the time there was a $30 coupon. So far it seems like a good printer, I am still getting used to the extruder setup due to the Boden setup, switching filament isn't quite as easy as before. The print quality on the other hand is far better than the Anet A8.

https://amzn.to/3hwQU9W

#3Dprinting
#Bowflex

Видео Creality Ender 3 V2 - Stop Stringing, Improve Print Quality & Time With These Two Settings канала NeedItMakeIt