DIY 3D Printed VTOL UAV | ArduPilot AET405WING + ELRS + IPC Digital FPV Build & Flight Test

📝 Optimized YouTube Description (Emoji Version)
🚀 This is a fully DIY 3D printed VTOL UAV build and flight test based on ArduPilot.
🧠 The aircraft is built around the AET405WING flight controller running ArduPilot, combined with a 2.4G ELRS control system and IPC digital FPV link for stable long-range communication.
⚡ Power system:
🔋 6S 21700 8000mAh battery
🌀 3120 700KV motor
🪶 10x6 propellers
📡 Navigation system:
📍 252Q GPS module for positioning and return-to-home functions
✈️ This aircraft is designed for stable vertical hover, smooth transition to fixed-wing flight, and long-endurance cruising efficiency.
🧩 The entire airframe is fully 3D printed, from design and slicing to final assembly and flight testing.
🎥 In this video you will see:
🖨️ 3D printing process of UAV airframe
🧪 Material selection (ABS / ASA)
💻 ArduPilot AGC ground station setup
🔧 Full assembly process
🌪️ Hover stability test in wind conditions
🔄 Transition to fixed-wing flight mode
🎮 FPV first-person flight footage
🏁 A complete UAV build from filament to a fully functional flying aircraft.
🔑 Keywords (SEO)
3D printed UAV • VTOL drone • ArduPilot • AET405WING • ELRS • FPV drone • DIY drone build • fixed wing UAV • long range FPV • IPC digital FPV • VTOL fixed wing • UAV flight test

00:00 Introduction
00:22 Choosing the Best 3D Printing Filament
00:37 ArduPilot Flight Controller Setup
01:05 Airframe Assembly
03:56 Flight Controller Installation & VTOL Tilt Calibration
04:38 VTOL Hover & Flight Test
05:55 Transition to Fixed-Wing | FPV Stability Test

Видео DIY 3D Printed VTOL UAV | ArduPilot AET405WING + ELRS + IPC Digital FPV Build & Flight Test канала Han_Fpv