Volkswagen Polo headlights DRL Modification

This video is about installation of after-market 2 in 1 LED lights which work as DRL's (Daytime Running Lights) and also the flowing turn signal indicators.
Full precautions and safety measures are taken during the installation of these lights. This is advised that you should not attempt doing it yourself if you have no basic knowledge of electronics and car components. If you are not expert enough then kindly get this installation done safely by an expert.

We first installed these lights in our Volkswagen POLO and then One of our brother liked them and we did it for his Ford Figo Aspire as well.

Lights are easy to install.
LED DRL lights have only 3 connection wires.
1. The main power source 12v + wire mostly in RED color.
2. The black wire which is (-). Connect that to ground of your car's body or directly to the negative terminal of the battery.
3. Third wire which is Yellow or Orange is the switch wire for the Turn Signal. This needs to be connected to the turn signal bulb's 12v(+) point.

Important Instructions to Install very carefully:
If you hear some strange sound, a strange smell or smoke comes or any wire starts heating then immediately remove connections. First install with temporary connections. If all goes well only then make connections permanent. Wrong fitting can damage your car's expensive electronic components. So be very careful and do it only if you know what you're dealing with.

Motive of this video to show you a method to install aftermarket lights without cutting the original wiring. This way you can remove this accessory in case you need to make a warranty claim from the manufacturer company or insurance company.

Enjoy the Video

Thanks for being on our channel.

Видео Volkswagen Polo headlights DRL Modification канала Mechankey