Switch Port Security Configuration – Cisco Packet Tracer Tutorial

00:00 Part 1: Configure Devices

Switch enable
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# ip address 10.10.10.2 255.255.255.0
Switch(config-if)# no shutdown

01:16 Part 2: Configure Port Security

S1# configure terminal
S1(config)# interface range fastEthernet 0/1-2
S1(config-if-range)# switchport mode access
S1(config-if-range)# switchport port-security

S1(config-if-range)# switchport port-security maximum 1

S1(config-if-range)# switchport port-security mac-address sticky

S1(config-if-range)# switchport port-security violation restrict

S1(config-if-range)# exit
S1(config)# interface range fastEthernet 0/3-24, gigabitEthernet 0/1-2
S1(config-if-range)# shutdown

13:25 Part 3: Verify Port Security

S# show running-config

S1# configure terminal
S1(config)# interface range fastEthernet 0/3
S1(config)# no shutdown

S1# Show port-security interface fastEthernet 0/2
OR
S# show port-security (it will show table )
#cisco
#packettracer
#switch
#switchportsecurity
#networking
#network
#ccna

Видео Switch Port Security Configuration – Cisco Packet Tracer Tutorial канала CybNet Tutorials