DarwinFPV Baby Ape setup guide with ELRS receiver

Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST: https://www.fpvknowitall.com/ultimate-fpv-shopping-list

SUPPORT ME ON PATREON at: http://bit.ly/2Ep5Sia

THIS IS MY FULL TIME JOB. Here are other ways that you can support me: https://www.fpvknowitall.com/support-me/

---

I receive a commission (at no extra cost to you) if you make a purchase after clicking one of the affiliate links below.

The camera on the original Baby Ape is, in my opinion, barely usable. I strongly suggest choosing the Baby Ape Pro with upgraded Caddx Ant antenna.

Buy the DarwinFPV Baby Ape 3 at:
* DarwinFPV (both pro and basic) - https://bit.ly/3xUS5JL
* RaceDayQuads - https://bit.ly/3qZXVb2
* Pyro-Drone (pro only) - https://bit.ly/3xPhW64
* Banggood - https://bit.ly/3oVSyIS

MANDATORY DISCLAIMER: I am a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for me to earn fees by linking to Amazon.com and affiliated sites.

--- TABLE OF CONTENTS ---

0:00 - Introduction
0:54 - Open the top plate to prepare to install the receiver

My soldering tutorial: https://youtu.be/GoPT69y98pY

3:15 - Which receiver to install?
4:31 - Solder and mount the receiver

How to figure out quadcopter wiring diagrams (what wire goes where?) - https://youtu.be/APfDzb6fIoY

11:07 - Function check before reassembly

Adding ELRS to the Jumper T-Lite: https://youtu.be/EPPk4yFU9tQ

12:35 - Configure Betaflight for the receiver

Download Betaflight Configurator at: https://github.com/betaflight/betaflight-configurator/releases

How to set up channel mapping and endpoints: https://youtu.be/1azl1f8qJ84

How to set up aux modes: https://youtu.be/feObDe54wKw

17:45 - Other small Betaflight changes from DarwinFPV default config

My analog OSD setup: https://pastebin.com/aDw5PNVv

20:50 - Conclusion

Props for beginners: https://youtu.be/nc1QG_Njo7Y

Видео DarwinFPV Baby Ape setup guide with ELRS receiver канала Joshua Bardwell