Denford Sherline CNC Arduino Upgrade Part 1

Part 2 https://youtu.be/woJQvjjx0l4

Arduino is running GRBL with the serial monitor being used to send simple commands. None of the axies on the lathe seem to work but the drivers are holding the steppers in place so I need to figure that out.

Credit to these videos in helping get this set up:
https://www.summet.com/blog/2016/01/16/how-to-convert-a-denford-scantek-2000-micromill-to-linuxcnc-mach3-control-part-1-3-axis-control/
https://www.youtube.com/watch?v=1ioctbN9JV8&t=430s

Видео Denford Sherline CNC Arduino Upgrade Part 1 канала Joe Malovich