Removal Of Old Led From Chip #ledbulb

Here’s a step-by-step guide to test a bulb chip using a digital multimeter:

Tools Needed:
• Digital Multimeter
• Soldering tools (if replacement is needed)
• Replacement SMD LEDs (if damaged)

Step-by-Step Guide:

⸻

1. Power Off and Safety Precautions
• Disconnect the bulb from the power source to avoid any electrical shock or damage.
• Discharge any capacitors on the circuit for safety.

⸻

2. Set the Multimeter to Diode Mode
• Turn the digital multimeter dial to diode mode (indicated by a diode symbol).
• Diode mode allows you to test the voltage drop across individual diodes or LEDs.

⸻

3. Check the Multimeter Function
• Test the multimeter by touching the two probes together; the screen should show a reading near 0.5V-1.0V (depending on your multimeter).

⸻

4. Test Each SMD LED on the Bulb Chip
• Place the black (negative) probe on the negative terminal of the SMD LED.
• Place the red (positive) probe on the positive terminal of the LED.
• Look for continuity: A healthy LED will show a small voltage drop (typically around 1.8V-3.2V depending on the LED type). If there is no reading or the multimeter shows “OL” (overload), the LED is damaged.

⸻

5. Inspect the Other Components
• If necessary, test other components on the bulb chip (e.g., resistors, capacitors) by setting the multimeter to the appropriate resistance or capacitance mode.
• This step ensures that the issue is isolated to the SMD LEDs.

⸻

6. Record and Identify Faulty Components
• If any LEDs show no voltage drop or continuity, mark them as faulty.
• Replace the damaged LEDs or other faulty components.

⸻

7. Verify the Entire Circuit
• After replacing any faulty parts, repeat the testing on all LEDs to ensure everything is functioning correctly.

⸻

8. Reassemble and Test the Bulb
• After repairs, reassemble the bulb and reconnect it to the power source.
• Test the bulb to ensure it is working properly.

⸻

Conclusion

By following these steps, you can effectively test the SMD LEDs on a bulb chip with a digital multimeter. If you find any faulty LEDs, replace them, and recheck the bulb’s functionality.

Let me know if you need more details or a different procedure!
#ledbulb #ledsmd #shortsfeed #shortsyoutube #youtubepakistan #viralvideo

Видео Removal Of Old Led From Chip #ledbulb канала Qureshi Store (Repairing)