Fancy swirl earrings - Cheryl St. Pierre - retired

Supply list below

Please subscribe and hit the bell to get the notification of all my new videos. I need your support to keep this channel going.
Measurements for the tutorial.
~ bend the 20 gauge wires 3 inches (7.5cm) from the end and make a loop using the longer end.
~ Measure 5 mm to make second loop, that will hug the side of the pearl.
~ snip the 26 gauge wire ends (that we used to put on the pearl) to about 5mm and make a spiral at the end to finish off ends.
~ snip the bottom ends of the 20 gauge wire to a length of 7mm from the center wire at the back, then make filigree swirls.

Supply list
Note that I use soft copper wire.
2 - 8 inch (20cm) pieces of 20 gauge (0.81mm) soft wire.
2 - 4 inch (10cm) pieces of 26 gauge (0.4mm) soft wire.
2 - 4mm cultured or freshwater pearls
flush cutters
round nose pliers
chain nose pliers
ear wires of choice.

Note: I had a very negative lady comment that I was using the wrong tools and left unsightly marks on my earrings.. If you feel that you would like to use bent nose pliers for your earring by all means, however I would like you to try and make a pair of earrings looking through a camera instead of the real thing.. it shoots your depth of field way off. She said I should have redone the tutorial without mistakes.. I am human and I am not ashamed to show it. This is me.. take me as I am. Please do not write mean and critical comments on my tutorials. Thank you.

Видео Fancy swirl earrings - Cheryl St. Pierre - retired канала Cheryl St.Pierre