FIXED! DJI Phantom 4 Pro Remote Control Battery Charge Issue [Disassembly, Repair, Reassembly]

Links to tools featured in this video:

Heat gun/reflow station (updated version): https://www.amazon.com/VIVOHOME-Soldering-Rework-Station-Nozzles/dp/B07JX641M7/
Screwdriver and tool set: https://www.amazon.com/gp/product/B076LJRWGP/

Not featured in video, but used during the repair:

Helping Hand stand: https://www.amazon.com/gp/product/B071NDZRPZ/
Voltmeter: https://www.amazon.com/gp/product/B071JL6LLL/
Extra reflow solder (not needed in my repair, but some may need it if there is too little solder left to reflow): https://www.amazon.com/gp/product/B0195V1QEI/

UPDATE! : A viewer using this method had good results using a higher reflow temperature (350° C) for shorter time and helpfully suggests using thermal tape to protect plastic pieces! See the comments section.

For a look at performing the actual reflow, check out Mark Dean’s video: https://youtu.be/yue5sCW6K3w

ORIGINAL DESCRIPTION: This video describes a possible fix to the DJI Phantom 4 Pro controller failing to charge or show an accurate battery charge. By reflowing key connecting points on the controller's circuit board, I was able to restore full functionality.

Did this technique work for you? Please leave any comments or questions in the comments area!

Mentioned in this video:

DJI message boards post by Rainer1: https://forum.dji.com/thread-116313-1-1.html

Videos by Robson Raul (Portuguese language): https://www.youtube.com/channel/UCcApFx1zdTlvuB4TQQtjAWA/videos

Please note that this technique may involve risk and should only be attempted if your device is unable to be repaired by a professional technician. Any attempted repair is done at your own risk!

Видео FIXED! DJI Phantom 4 Pro Remote Control Battery Charge Issue [Disassembly, Repair, Reassembly] канала travel | photo | film