$200 Dividing Head | Teardown
G'day everyone,
A quick follow up to last weeks introduction to the new DS-0 diving head that I purchased off aliexpress for $200. Last week I gave it an overview and unboxing, however I was unable to take it apart due the the backplate which was sized in place.
This week, using some suggestions that I received, I was able to finally get the backplate unscrewed.
In this video I will disassemble the dividing head to look at the inner components, give them a clean to remove any grit or crud, and replace the grease and oil.
I hope you enjoy the video.
$200 Dividing Head Disassembl
Timestamps
0:00 - How I Got The Chuck Off
1:09 - Disassembling The Dividing Head
4:28 - Cleaning The Dovetails And Base
5:30 - Reassembly
#workshop #dividnghead #DIY
Видео $200 Dividing Head | Teardown канала Artisan Makes
A quick follow up to last weeks introduction to the new DS-0 diving head that I purchased off aliexpress for $200. Last week I gave it an overview and unboxing, however I was unable to take it apart due the the backplate which was sized in place.
This week, using some suggestions that I received, I was able to finally get the backplate unscrewed.
In this video I will disassemble the dividing head to look at the inner components, give them a clean to remove any grit or crud, and replace the grease and oil.
I hope you enjoy the video.
$200 Dividing Head Disassembl
Timestamps
0:00 - How I Got The Chuck Off
1:09 - Disassembling The Dividing Head
4:28 - Cleaning The Dovetails And Base
5:30 - Reassembly
#workshop #dividnghead #DIY
Видео $200 Dividing Head | Teardown канала Artisan Makes
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Making A Fly Press For The Workshop | Part Two - The FrameMaking A Fly Press For The Workshop | Part OneThe 6 Best Lathe Projects For BeginnersMaking A TAP Follower - Should Have Made It a long Time AgoInstalling A DRO on my New Lathe (Digital Readout)I Had To Make a MASSIVE Tap Wrench. It's 270cm LongI Had To Make a HUGE 40mm Thread Tap - Its BIGMaking A Wedge Lock Quick Change Tool Post For The New LatheI Need a Custom Thread Tap - Shop Made TapMaking A BIG 200mm Fly Cutter For The Milling MachineMaking a BIG Set of V Blocks for the Milling Machine | Vise JawsMaking a 2 Piece Vise For The Milling MachineI Filled My Milling Machine With Lead, Cast Iron and Epoxy Granite. Here Is WhyI Put A 3HP Motor On My Mini MillThe New Lathe Has Some Issues, But I Can Fix ThemI Finally Bought A New Lathe - Hafco Al 250GThe $600 Mini Lathe - 4 Years laterHelical Milling Attachment For The Milling MachineDrilling Hardened Steel With Masonry Bits - Not A LifehackMist Coolant For The Mini LatheThe 3HP Mini Lathe..... It Scares Me