#104 Hypercube Evolution 3D Printer Build - 11 (Extruder Setup and Cal)

This finalises the hardware install and setup of the Titan Aero extruder. First I sort out the last thing on the hot end by tightening the nozzle as per the instructions and then I fit the motor driver for the extruder and give it a test. Lastly I calibrate the steps per mm.

I have covered off on getting the environment setup to make changes to the Marlin 2.0 firmware in another video, you can find it here:
https://youtu.be/4-vrkHP0v78

A big thank you to Scott 3D who published the design for the printer on Thingiverse, link below.

I will be providing any design files that I produce where there are changes so feel free to use and abuse anything I make available as you see fit as well.

https://www.thingiverse.com/thing:2254103

Here is a link to the facebook group for the Hypercube Evolution
https://www.facebook.com/groups/Hypercubeevolution/

If you like what you see, then please like and subscribe, you can also check out more information at my website:
http://www.grumpyoldtech.technology

or take a look at my Facebook page:
https://fb.me/GrumpyOldTech

If you want to get in contact, leave a comment or email me at
GrumpyOldTech@outlook.com.au

Видео #104 Hypercube Evolution 3D Printer Build - 11 (Extruder Setup and Cal) канала Grumpy Old Tech