10.8.1 Packet Tracer - Configure CDP, LLDP, and NTP

CCNAv7 - Enterprise Networking, Security, and Automation (ENSA)
Cisco CCNA3 Packet Tracer. Netacad, IT network.

Objectives:
In this activity, you will configure a router to receive time information over NTP and configure devices with CDP and LLDP.
• Configure CDP to run globally on a device.
• Disable CDP on device interfaces where necessary.
• Configure LLDP to run globally on a device.
• Configure LLDP to send and receive messages according to requirements.
• Configure a router to use an NTP server.

Background / Scenario:
A network administrator has been asked to investigate a new client’s network. Documentation is incomplete for the network, so some information needs to be discovered. In addition, the NTP server needs to be configured on a router. Discovery protocols must also be adjusted to control traffic discovery protocol traffic and prevent information about the network from being received by potentially unauthorized hosts.

Some of the device IP addresses are unknown to you. You must determine what the IP addresses are so that you can connect to the devices over SSH in order to configure them. You can enter them into the Addressing Table as you discover them.

Видео 10.8.1 Packet Tracer - Configure CDP, LLDP, and NTP канала Shi Liu