How to replace the element in a fan oven

How to replace the element in a Beko DVC61S fan oven.

My fan oven would start to heat up ok, but then tripped the cooker circuit breaker in the house fuse box. So I decided to replace the element to see if it would fix the problem. I bought a replacement 2100W element on eBay (UK) for £6.99 October 2021. (Unfortunately, this didn't fix the problem, so I will replace the thermostat next. -this didn't fix the problem either, so I replaced the fan motor and that fixed it.)

HOW TO REPLACE A FAN OVEN HEATER ELEMENT.
Before you start, make sure the oven is cold.
Turn off the cooker at the wall switch.
(If you're not sure you should switch off the cooker circuit breaker in the fuse box)
Open the oven door.
Remove the shelves and anything else in the way.
Undo the screws holding the cover panel in place.
Remove the element cover panel.
Pull out the cooker from the wall, so that you can access the rear panel.
Remove the Phillips screws holding on the rear panel.
Remove the rear panel.
Take a photo of the wiring to help when you attach the new element.
Remove the 2 Phillips screws holding the old element to the oven.
Remove the 3 wires from the terminals on the old element. (Avoid pulling by the wire because it may come off the spade connector.)
Remove the old element.
Offer up the new element.
Connect the 3 wires to the correct terminals on the new element.
Screw the new element to the oven.
Replace the rear panel.
Replace the screws in the rear panel.
Push the cooker back in to place.
Replace the element cover panel.
Screw the cover panel in to place.
Replace the shelves.
Close the oven door.
Turn on the cooker at the wall switch. (and circuit breaker if it was turned off.)
Turn on the fan oven to test it is working.
Done.

I hope this helps.

Видео How to replace the element in a fan oven канала Philip Wills