SNS 220: Shaping 28" Parallel Bars
Two pieces of 1" flame cut steel that I'm going to clean up in the shaper for a friend who wants to use them as parallels on his work bench. This is a great job for the shaper.
Abom79 t-shirts: https://www.storefrontier.com/store/abom79
Want to support this channel? https://www.patreon.com/abom79
Видео SNS 220: Shaping 28" Parallel Bars канала Abom79
Abom79 t-shirts: https://www.storefrontier.com/store/abom79
Want to support this channel? https://www.patreon.com/abom79
Видео SNS 220: Shaping 28" Parallel Bars канала Abom79
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
SNS 288 Machining an 18 Inch Straight EdgeMachining a Dake Arbor Press HandwheelSNS 204: Thread Repair Inserts, Boring Mill, Large Gearbox Build, G&E CatalogMore Thread Cutting & Heat Treating (I needed a metal tap)SNS 283: Busted Vise Repair, 69 Valiant Update, Texas PicksLeBlond Lathe Cross-Feed Nut Part 1Machining an Intake Manifold in the G&E ShaperA Brief Chat about Carbide ToolingSNS 294 Kubota Crankshaft Hot Shot 360SNS 300: Spray Welding a Blower ShaftShaping a Hydraulic Rod Clevis Part 1SNS 341: Machinist Jack Pattern for CastingSNS 228: Toolmex 6 Jaw Chuck, K&T Mill RepairsMachining a Cast Iron Bearing8in Roller Lathe Work Part 1Walker Turner Drilling Head Adaptor Part 2: Rotary Table Machining & FinishingForklift Axle Housing RepairSNS 225 Part 1: Headstock & Tailstock Alignment, Starrett Wall ChartsShaping a Tapered Bore Internal KeywaySNS 210: Acme Nut Threading