Refitting a Contessa 26 Part 6 - Stuffing Box Removal and Cutlass Bearing
Documenting the refit of a 1976 Contessa 26 – J.J. Taylor build. Not really a DIY video, just recording for my own reference.
Projects completed in this episode:
o Removed prop shaft flange in a “creative” way.
o Forced old cutlass bearing out.
o Installed new prop shaft flange and cutlass bearing.
Видео Refitting a Contessa 26 Part 6 - Stuffing Box Removal and Cutlass Bearing канала Epoxy and Butyl Tape
Projects completed in this episode:
o Removed prop shaft flange in a “creative” way.
o Forced old cutlass bearing out.
o Installed new prop shaft flange and cutlass bearing.
Видео Refitting a Contessa 26 Part 6 - Stuffing Box Removal and Cutlass Bearing канала Epoxy and Butyl Tape
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Refitting a Contessa 26 Part 7 - Rudder Plate and Yanmar Engine Mounts
Refitting a Contessa 26 Part 5 - Nav Station and New Wiring
Refitting a Contessa 26 Part 8 - Cockpit Drains, Steering and Finishing the Bilge
PSS Install Video
Cutlass Bearings
How to remove a cutlass bearing - Sailing A B Sea (Ep.120)
Replacing the cutless bearing on Anne Marie an Endurance 35 ketch
How to repack an old type of stern gland
REPLACING THE STERN TUBE - PART 1
A Contessa 26 in Greenland | #58 | DrakeParagon Sailing Season 5
That Sinking Feeling - a dripping stern tube
Repacking a Dripless Seal on an Inboard Boat
Packing Gland and Shaft Coupling Removal (#2)
Refitting a Contessa 26 Part 11 - Building Storage and a Folding Table
Feeling 286 Special cutless bearing (bagues hydrolube)
REPLACING THE STERN TUBE - PART 2
Refitting a Contessa 26 Part 14 - Launch, Boat Tour and Future Plans
Contessa Yachts By Jeremy Rogers
Shaft Alignment Part 2
#162 Alternative Way To Replace Cutless Bearing!