Schaublin 52 action - milling Raglan parts
More like a show-down of the Schaublin SV52 milling machine, but though it could be OK to see this.. and of me actually using it for something. Also evidence of a non-ideal setup (chatter when cutting gears mainly because I forgot to tighten the head bolts enough plus a somewhat out of true arbor). I didn't manage to document while milling the pockets in the apron casting itself after the silicon bronze repair, but I used a long shank end-mill and careful feed
Видео Schaublin 52 action - milling Raglan parts канала Jan Sverre Haugjord
Видео Schaublin 52 action - milling Raglan parts канала Jan Sverre Haugjord
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Myford Super 7 - short addendum on the use of a solid tool post in place of the topslideHBM45 - some hints during saddle- and base scraping and measurementsMyford Super 7 - Z axis drive possibilitiesMyford ML7 Tailstocks: foot and wiperWeiler Praktikant-1: replacing the on/off switch and assemblyMy mills & drillsCX 16 saddle - dovetails - measurements and scraping - 1Henrik's lairMyfordML7: partial restoration of 3 lathes, part-1 - intro and disassemblyMyford ML7: Cutting keyway in hardened countershaftMyford Super 7 - test cuts - part 1: with solid tool post and ELSHenrik's playground: planing Myford bedsCX-16 base: considerations and objectivesMyford Super7 spindle assembly, adjustment and testingParting off with front mounted tool on the MyfordPowell planerMyford cross-slides from grindingHBM45 - testing colum tilt with mounted head assemblyMyford ML7 - testing and adjusting the cross feed travelMyford ML10 Z and X axis feed systemsSiegX3 fixing head tilt