How to Hang a Flat-Screen TV | Ask This Old House
Electrician Scott Caron hangs a flat-panel TV on the wall and conceals all the wiring.
#ThisOldHouse #AskTOH
SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse
Shopping List for Hanging a Flat-Screen TV:
- TV wall-mounting bracket
- Old-work electrical box, for housing the recessed electrical outlet
- Recessed electrical outlet, used to provide power to the TV
- Two low-voltage rings with cover plates, for housing the audio-visual cables
- Nonmetallic electrical cable, provides power to the recessed electrical outlet
- Audio-visual cables, connects the TV to the cable box and DVD player
- Electrical tape, used to secure the cables to the fish tape
- Cable staples, for fastening the cables to the floor joists in the basement
- Infrared (IR) repeater and admitter, allows the TV remote control to operate the cable box and DVD player
- Lag screws, for securing the TV wall-mounting bracket to the wall studs
Tools List for Hanging a Flat-Screen TV:
- Utility knife or drywall saw, for cutting holes in walls
- Wire strippers, used to cut and strip wires
- Needle-nose pliers, used to break the tab off the electrical box
- Fish tape, for fishing wires through walls
- Screwdriver
- Hammer
- Drill/driver
Steps for Hanging a Flat-Screen TV:
1. Hold an old-work electrical box against the wall directly above an existing electrical outlet.
2. Trace the outline of the box onto the wall, then use a utility knife (or a drywall saw) to cut a hole through the drywall.
3. Repeat the previous steps to cut a hole for a low-voltage ring that will house the audio-visual cables.
4. Turn off the electrical power to the wall outlet.
5. Remove the cover plate from the outlet and unscrew and pull the outlet from the outlet box. Don't disconnect any wires.
6. Use needle-nose pliers to twist off the tab from the upper corner of the outlet box.
7. Push a length of nonmetallic electrical cable into the outlet box and up the wall to the hole cut earlier in Step 2.
8. Connect one end of the cable to the recessed electrical outlet, and connect the opposite end to the existing electrical outlet.
9. Install a low-voltage ring to the hole cut in Step 3.
10. Use a fish tape to pull audio-visual cables up from the basement and through the low-voltage ring.
11. Pull the ends of the audio-visual cables through a cover plate, then screw the plate to the low-voltage ring.
12. Extend the audio-visual cables from the TV location to the location of the cable box and DVD player.
13. Cut a hole in the wall near the cable-box location and install a second low-voltage ring.
14. Pull the audio-visual cables up from the basement and through the low-voltage ring.
15. Attach an infrared (IR) repeater to the TV.
16. Mount an infrared (IR) admitter to the IR window on the cable box and on the DVD player.
17. Make the audio-visual cable connections to the cable box and DVD player.
18. Screw the TV wall-mounting bracket to the wall studs and to the back of the TV using lag screws.
19. Hang the TV onto the the wall-mounting bracket.
20. Connect the wires to surround-sound speakers, then mount the speakers to the wall.
21. Turn the power back on.
About This Old House TV:
This Old House is the No. 1 multimedia home enthusiast brand, offering trusted information and expert advice through award-winning television, a highly regarded magazine, and an information-driven website. This Old House and Ask This Old House are produced by This Old House Ventures, LLC and are presented on PBS by WGBH Boston.
Follow This Old House and Ask This Old House:
Facebook: http://bit.ly/ThisOldHouseFB
Twitter: http://bit.ly/ThisOldHouseTwitter
http://bit.ly/AskTOHTwitter
Pinterest: http://bit.ly/ThisOldHousePinterest
Instagram: http://bit.ly/ThisOldHouseIG
Tumblr: http://bit.ly/ThisOldHouseTumblr
How to Hang a Flat-Screen TV | Ask This Old House
https://www.youtube.com/user/thisoldhouse/
Видео How to Hang a Flat-Screen TV | Ask This Old House канала This Old House
#ThisOldHouse #AskTOH
SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse
Shopping List for Hanging a Flat-Screen TV:
- TV wall-mounting bracket
- Old-work electrical box, for housing the recessed electrical outlet
- Recessed electrical outlet, used to provide power to the TV
- Two low-voltage rings with cover plates, for housing the audio-visual cables
- Nonmetallic electrical cable, provides power to the recessed electrical outlet
- Audio-visual cables, connects the TV to the cable box and DVD player
- Electrical tape, used to secure the cables to the fish tape
- Cable staples, for fastening the cables to the floor joists in the basement
- Infrared (IR) repeater and admitter, allows the TV remote control to operate the cable box and DVD player
- Lag screws, for securing the TV wall-mounting bracket to the wall studs
Tools List for Hanging a Flat-Screen TV:
- Utility knife or drywall saw, for cutting holes in walls
- Wire strippers, used to cut and strip wires
- Needle-nose pliers, used to break the tab off the electrical box
- Fish tape, for fishing wires through walls
- Screwdriver
- Hammer
- Drill/driver
Steps for Hanging a Flat-Screen TV:
1. Hold an old-work electrical box against the wall directly above an existing electrical outlet.
2. Trace the outline of the box onto the wall, then use a utility knife (or a drywall saw) to cut a hole through the drywall.
3. Repeat the previous steps to cut a hole for a low-voltage ring that will house the audio-visual cables.
4. Turn off the electrical power to the wall outlet.
5. Remove the cover plate from the outlet and unscrew and pull the outlet from the outlet box. Don't disconnect any wires.
6. Use needle-nose pliers to twist off the tab from the upper corner of the outlet box.
7. Push a length of nonmetallic electrical cable into the outlet box and up the wall to the hole cut earlier in Step 2.
8. Connect one end of the cable to the recessed electrical outlet, and connect the opposite end to the existing electrical outlet.
9. Install a low-voltage ring to the hole cut in Step 3.
10. Use a fish tape to pull audio-visual cables up from the basement and through the low-voltage ring.
11. Pull the ends of the audio-visual cables through a cover plate, then screw the plate to the low-voltage ring.
12. Extend the audio-visual cables from the TV location to the location of the cable box and DVD player.
13. Cut a hole in the wall near the cable-box location and install a second low-voltage ring.
14. Pull the audio-visual cables up from the basement and through the low-voltage ring.
15. Attach an infrared (IR) repeater to the TV.
16. Mount an infrared (IR) admitter to the IR window on the cable box and on the DVD player.
17. Make the audio-visual cable connections to the cable box and DVD player.
18. Screw the TV wall-mounting bracket to the wall studs and to the back of the TV using lag screws.
19. Hang the TV onto the the wall-mounting bracket.
20. Connect the wires to surround-sound speakers, then mount the speakers to the wall.
21. Turn the power back on.
About This Old House TV:
This Old House is the No. 1 multimedia home enthusiast brand, offering trusted information and expert advice through award-winning television, a highly regarded magazine, and an information-driven website. This Old House and Ask This Old House are produced by This Old House Ventures, LLC and are presented on PBS by WGBH Boston.
Follow This Old House and Ask This Old House:
Facebook: http://bit.ly/ThisOldHouseFB
Twitter: http://bit.ly/ThisOldHouseTwitter
http://bit.ly/AskTOHTwitter
Pinterest: http://bit.ly/ThisOldHousePinterest
Instagram: http://bit.ly/ThisOldHouseIG
Tumblr: http://bit.ly/ThisOldHouseTumblr
How to Hang a Flat-Screen TV | Ask This Old House
https://www.youtube.com/user/thisoldhouse/
Видео How to Hang a Flat-Screen TV | Ask This Old House канала This Old House
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
How to mount a TV to the wall (like a pro)How to Install a Water Filter Under the Sink | Ask This Old HouseHow To Install Power And HDMI Wires In The Wall For a Flat Screen TV | THEHANDYMAN |2 ways to hang TV on wall mount into stud and drywall reviewHow to Hide TV Wires | Code Compliant TV WiringHow to Upgrade an Electric Meter to 200-Amp Service (Part 1) | This Old HouseHow To Hang A Flat Screen TV Fast And EasyHow to Choose and Install Laundry Appliances | Ask This Old HouseHow to Fix and Upgrade a Weak WiFi Signal | Ask This Old HouseBest TV Mounts on Amazon and Costco + Mantel Mount infoHow To Hide TV Wires | DIY For BeginnersHow to Properly Mount a TV to a Wall: Step by StepAsk This Old House | Metal Railing, Tile Replacement (S16 E17) | FULL EPISODEHow to Hang a Kitchen Wall Cabinet | Ask This Old HouseHow to Add an Electrical Outlet for a Wall Mounted TV5 Mistakes People Make When Mounting a TVHow To Wall Mount a TV (LED & LCD) - Abt ElectronicsHow to Replace a Garage Door Opener | Ask This Old HouseHow To Hide Your TV Wires in 30 Minutes - DIYHow to Repair a Broken Doorbell | Ask This Old House