The simplest table saw crosscut sled on YouTube. Essential woodworking shop project.

ESSENTIAL jigs and accessories every woodworker needs. Free plans ► http://myshopjigs.com
I've made crosscut sleds before, but this time I wanted to strip out any frills and make this simple version that anyone can make in a couple hours in their workshop.

One of the most common cuts to make on a table saw is a crosscut. Unfortunately, the only tool for making crosscuts that comes with a tablesaw is a miter gauge. You can usually get by with these and make cross cuts that are good enough for most projects. But there are some problems miter gauges.

The biggest issue with miter gauges is accuracy. Since they are designed to be rotated at various angles, they might not always lock back in at a perfect 90 degrees for a crosscut.

An improvement would be an aftermarket miter gauge like the one I use from Incra.(https://amzn.to/3vEdmGa) It has a built in extendable fence and a pretty good system for locking it into place. But you can only support one side of your cut.

And finally, your cuts can be affected by any play that might be in the miter slot since it only uses one of your saw’s slots.

A crosscut sled addresses all of these concerns and is one of the most useful woodworking jigs you can make for your saw. With a well calibrated crosscut sled, you can be assured of perfect 90 degree cuts every time without having to adjust anything.

It has two runners, one for each miter slot to assure that there’s no wiggle. Both sides of your workpiece are supported, and its zero clearance kerf gives you much cleaner cuts with less tearout. You can safely cut small pieces without them dropping into your saw. And the best part is that you can clamp a stop block anywhere along the fence on either side of the blade for making repeated cuts.

Thanks for watching this series on woodshop accessories and jigs. Please see them all, and download free plans over at http://myshopjigs.com

Chapters:
0:00 Why you need a crosscut sled
3:27 Making the runners
5:00 Attaching the runners
8:27 Making and attaching the fences
14:30 Making the blade guards
MY PODCAST:
Apple Podcasts► https://bit.ly/chadandsteveitunes
Spotify► https://bit.ly/chadandstevespotify
YouTube► https://www.youtube.com/c/ChadandSteve
Website► http://chadandsteve.com/

Sign up for my free monthly newsletter: http://notesfromsteve.com/

PATREON ►► https://www.patreon.com/wwmm
TOOLS I USE► https://amzn.to/2F3hxQc
WWMM T-SHIRTS► http://amzn.to/2scxfYl
FACEBOOK► https://www.facebook.com/WoodworkingForMereMortals
INSTAGRAM► http://instagram.com/steveramsey_wwmm

MAILING ADDRESS:

WWMM
448 Ignacio Blvd. # 237
Novato CA 94949
----------------
Woodworking for Mere Mortals® is a registered trademark of ZRAM Media, LLC.
#woodworking #shopproject #tablesaw

Видео The simplest table saw crosscut sled on YouTube. Essential woodworking shop project. канала Steve Ramsey - Woodworking for Mere Mortals