CNC G0704 Part 1 - Software & Electronics Test

Video showing the installation and setup of Mach3, the wiring of one axis and then testing (There are no shots of a G0704 in this video.. maybe Part 2 of 3, depends what order the parts arrive in)

Dell Dimension Desktop with a 2Ghz Pentium 4 & 768mb RAM with on board parallel port for Mach3..

For Electronics I'm using the "Hoss CNC package" Option D.

http://www.g0704.com/G0704_electronics.html

Which consists of -

C10 Bidirectional Breakout Board

http://www.automationtechnologiesinc.com/products-page/breakout-boards/c10-bidirectional-breakout

KL-5056D Digital Bipolar Stepper Motor Driver-32 bit DSP Based

http://www.automationtechnologiesinc.com/products-page/digital-stepper-motor-driver/digital-stepper-driver-kl-5056d-heat-sink-is-included

NEMA23 570oz/in 5A 3/8" Dual Shaft Stepper Motor (KL23H2100-50-4B)

http://www.automationtechnologiesinc.com/products-page/nema-23/nema-23-three_eighths-inch-dual-shaft-with-a-flat-570-oz-in

48VDC/12.5A Switching CNC Power Supply

http://www.automationtechnologiesinc.com/products-page/switching-power-supply/48v12-5a-switching-cnc-power-supply-kl-600-48-duplicate

The link for the wiring schematic is here -

http://www.automationtechnologiesinc.com/wp-content/uploads/downloads/2012/08/KL-5056DWithC10.pdf

Видео CNC G0704 Part 1 - Software & Electronics Test канала n1bpd