Проверка работы корректоров фар outlander 3 без MUT

DRIVE TEST PROCEDURE (WHEN THE M.U.T.-III IS NOT USED)

1.Turn the hazard warning lamp switch to the ON position.
2.Within 10 seconds after turning the electric motor switch from OFF to the ON position (do not start up the plug-in hybrid EV system), turn the headlamp switch from OFF to ON 5 times repeatedly. If you fail to do this, turn the electric motor switch to OFF once and repeat from the beginning.
3.Within 30 seconds after you complete the step above successfully, turn off the hazard warning lamp switch.
4.The headlamp beam moves downward for approximately 3 seconds and upward for 3 seconds. Then the beam returns to the position applicable to the present vehicle posture.
5.The drive test is completed.

Видео Проверка работы корректоров фар outlander 3 без MUT канала strelokreg