Mercury Tracer Replacement Remote Programming 1999 2003

Visit us at http://www.carandtruckremotes.com/
MERCURY TRACER PROGRAMMING INSTRUCTIONS

1) Turn ignition of your Tracer from OFF to RUN (as far as you can go without cranking the engine) 8 times (one turn is from OFF to RUN and back to OFF) within 10 seconds, with the 8th time ending in RUN (8th time you only go from OFF to RUN and stop there) (do not start the engine).

2) All doors of your Tracer will lock then unlock to confirm programming mode.

3) Within 20 seconds, press any button on 1st Tracer car remote transmitter. Door locks will cycle to confirm remote programming.

4) Within 20 seconds, press any button on 2nd Tracer transmitter (up to 4 transmitters total possible). You have to press a button on every remote you have, including all the working original remotes if avail.

5) Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.

Видео Mercury Tracer Replacement Remote Programming 1999 2003 канала carandtruckremotes