Infiniti FX45 Replacement Remote Programming 2004 2007

Visit us at http://www.carandtruckremotes.com/
Please read carefully before trying! If at any time you make a mistake, start and stop your car, exit the vehicle and start over. The remote can be only programmed with a master key

1. Sit in Infiniti FX45 car with doors and windows closed.

2. Lock Infiniti FX45 doors with power door lock switch on driver's door.

3. Put in and pull out key from Infiniti FX45 ignition approx. 8 times or until you see the hazard/turn signal lights flash.(older models lights may flash after 4 or 5 times) you need to do that in less then 10 sec

4. When hazard lights flash (on 2005 and newer models the gauge needles may jump a little instead) , put key in ignition and turn to the acc position.(when your hazard lights flash your car is sending a signal to be received by the remote)

5. Press Infiniti FX45 lock button on the new remote, lights should flash again.

If you have 2 remotes, 1 new and 1 old or 2 new ones, please continue with steps 6 and 7. If not, skip to end.

6. Press Infiniti FX45 unlock button on driver's door, then lock button on drivers door, lights will again flash

7. Press lock button on 2nd new or old Infiniti remote transmitter. Lights again will flash.

You are done. Exit Infiniti FX45 vehicle and try your remote. It will not work from inside car or with key in ignition.
Note: if your hazard lights flash after inserting your key in and out, but you can't get the remote to program, you may have a dead battery or the wrong remote. If instructions do not work, do it again but when you get in - shut the door, buckle seat belt and lock doors, then proceed to putting key in ignition

Видео Infiniti FX45 Replacement Remote Programming 2004 2007 канала carandtruckremotes