Simpson Washing Machine Diagnostics Menu - EZI sensor Inverter

Accessing the diagnostic menu on your Simpson front loading washing machine is a good start to solve the problem with your washing machine.
In the diagnostics menu you can actuate and test different components individually to see how they perform and get a read out of the last fault code that occurred.

To access the diagnostics menu:
1. Make sure the machine has power and turn it off by the power switch.
2. Press the power button to turn on the machine.
3. Once the machine has powered up, simultaneously press START/PAUSE button and the nearest options button for approximately 3 seconds until the LEDs begin to flash.
4. Press the P (program button) for about 2 seconds to start the diagnostic mode.
5. 1st Cycle light - Door lock and Wash solenoid valve.
6. Each time the P (Program button) is pressed the machine actuates a different component.
7. 2nd Cycle light - Door lock and Pre-Wash solenoid.
8. 3rd Cycle light - Door lock, Pre-Wash and Wash Solenoid.
9. 4th Cycle light - Door lock and on some machines 3rd solenoid.
10. 5th Cycle light - Door lock and 4th solenoid (hot valve) only on some machines.
11. 6th Cycle light - Door lock and heating element, water temperature will be displayed on the LCD screen. If water level not above the heating element, machine will fill enough water to cover the element and will start to heat the water.
12. 7th Cycle light - Door lock, and wash motor. If water level below heating element, machine will fill water. Motor will turn clockwise at 55 rpm and then 250 rpm anti-clockwise. Motor speed displayed on screen, times the value displayed on LCD screen by 10 to get drum rpm.
13. 8th Cycle light - Drain pump and drum spin. First the drum will spin at 650 rpm then at max speed. Drum rpm displayed on screen. Times the value on LCD screen by 10 to get drum rpm.
14. 9th Cycle light - Nothing is tested here.
15. 10th Cycle light - Last fault is displayed.
16. It is a good practice once the machine is fixed to clear the fault code. To clear the fault code, simultaneously press the start/pause button and nearest option button, hold them for 3-5 seconds until the fault is cleared.
17. Turn off the machine to exit the diagnostics mode.

Thanks for watching. Please like and subscribe so that I can make more helpful videos.

To see the meaning of washing machine fault codes check out our website: https://appliancefault.com.au/faults/washing-machine-faults/simpson-washing-machine-fault-codes/

If we have helped you solve the problem with your machine and you would like to tip us, this can be done on out website through paypal: https://appliancefault.com.au/donate/

Видео Simpson Washing Machine Diagnostics Menu - EZI sensor Inverter канала Appliance Fault