How to swap Ublox M8N Pixhawk Connectors
How to swap the Ublox M8N 5 pin Molex connector to the 6 pin connector for pixhawk so that you can use this GPS module on your pixhawk autopilot. For more information please visit http://www.dronetrest.com/t/swapping-neo-7n-neo-m8n-gps-connector-for-pixhawk-apm/840
Видео How to swap Ublox M8N Pixhawk Connectors канала Unmanned Tech
Видео How to swap Ublox M8N Pixhawk Connectors канала Unmanned Tech
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
(1/5) PixHawk Video Series - Simple initial setup, config and calibration#54 Solder Paste Technique without StencilThe Cube Black Bundle (Pixhawk 2.1 + Here 2 GPS ) - Unboxing und Kurzvorstellung (DEUTSCH)Ublox NEO-M8N GPS Not working.3DR Pixhawk Installation Part 1 - Physical ConnectonsDIY SMD Solder PasteVoltlog #146 - Is My NEO M8N GPS Module Fake?Part #6A - Soldering Up the NEO-M8N GPS 📡 Unit for iNav [Omnibus F4 V1]Binding and Setting Up the FlySky i6 Transmitter for a quadcopter/droneHow to Wire & Setup FPV Drone With GPS - Betaflight GPS & GPS Rescue Mode - Never Lose a Drone AgainHow To Crimp Electrical ConnectorsHow do I get my GPS working with iNav?How Israel became a leader in water use in the Middle EastUpgraded XT60 failHow to setup a Pixhawk flight controllerPixhawk2 Cube Ayrıntılı İnceleme - ArduCopter Firmware Update - ArduPilot Ayarlar - SettingsHow to: Salvage puffed bloated Li-Po batteryFlite Test - Soldering Battery Connectors - FLITE TIPFrsky Taranis Qx7 ACCESS Basic SetupZD550 with Pixhawk 2.4.8 build